Specifications

Page 14
Online Support at www.digisender.net
DG440 DigiSender™ X7
TROUBLESHOOTING Picture Problems
Q: What do you see on your second television?
The picture is present but
poor quality
I see black or blank screen
Switch OFF your DigiSender® TRANSMITTER
What do you now see at the second TV?
I still see a Black Screen...
WRONG AV TV
CHANNEL SELECTED
1. Switch the transmitter back
on.
2. Ensure the correct SCART
channel is selected on your
second television. Some
televisions feature multiple AV
channels for one or more
SCART, phono and S-Video
inputs.
3. If available try another SCART
socket on the remote television
POOR RANGE
1. The picture & sound quality is
affected by the transmitter and
receiver’s location. Try
positioning them in different
locations. The transmitter and
receiver must be connected to a
mains extension lead that can be
moved.
2. Try the 3 other available
channels ensuring that the
audio/video channel is set to the
same on both the transmitter
and receiver
3. Ensure the units are within
the usable range, normally this
would be 40m when passing
through 2 average internal walls.
Thicker or stone/granite walls
may lower the usable range of
this device.
RECEIVING BLANK
SIGNAL
1. Switch the transmitter on.
2. Ensure the transmitter is
connected to your source device.
3. Ensure that the source
equipment is switched on (such
as your satellite or freeview box)
4. Use the supplied remote
control to select the correct
input channel. This can be done
at either the transmitter or
receiver.
I now see a snowstorm or
blue screen...
Page 11
Please read this instruction manual carefully prior to installation
DG440 DigiSender™ X7
continued...
STEP 4
Connect the power supply unit to the socket
labelled PSU.
STEP 6
STEP 5
Press the POWER button on your DigiSender
remote control to switch the receiver on. The
power LED will be green to indicate the device is
switched on.
Switch on the second television and select it’s
SCART channel. This will be labelled on the
remote control as one of the following buttons:
AV, VIDEO, VCR, AUX, SCART,
EXT, 0
Refer to your tv’s manual for further assistance.
Connect the power supply unit (PSU) to an
available wall socket.
BEDROOM
BEDROOM
BEDROOM
Did you know? The receiver can be connected to a Hi-Fi unit using
the Left & Right Audio outputs on the rear of the DigiSender™receiver unit.
Phono cable may be required.