Troubleshooting guide

Page 07Please read the instructions carefully prior to installation
DGXDSDV112 - DigiSender® XDHDMI - Single Input HDMI AV Sender System
ENGLISH (EN)
Installing your DigiSender® XDHDMI
Step 4 - Install the Receiver
The Receiver will pick up the signals being sent by your Transmitter and output them to a connected
TV.
Connect the Power Supply Unit (PSU) to the socket
labelled ‘PSU’ on the back of the DigiSender® Re-
ceiver and plug it into an available mains socket.
The Power Indicator will light up Red to indicate that
the unit is in Standby Mode.
2.
Use one of the included HDMI cables and connect
it to the socket labelled ‘HDMI OUT’ on the back of
the DigiSender® Receiver and the HDMI input on
your receiving TV.
1.