Troubleshooting guide

Page 07Please read the instructions carefully prior to installation
DG180-S - DigiSender® xSender™ - Single Input 2.4GHz Wireless AV Sender System
Connect the Power Supply Unit (PSU) to an avail-
able mains socket.
4.
Locate a vacant SCART socket on the back of your
receiving TV and insert the DigiSender® SCART
cable.
1.
Installing your DigiSender®
Step 3 - Install the Receiver
The Receiver will pick up the signals being sent by your Transmitter and output them to a connected
TV.
Ensure that the Audio/Video Channel switch on
the back of the Receiver is set to 1.
2.
Connect the Power Supply Unit (PSU) to the socket
labelled ‘POWER’ on the rear of the Receiver.
3.