Troubleshooting guide

Connect the Power Supply Unit (PSU) to an avail-
able mains socket.
6.
Page 06 Please read the instructions carefully prior to installation
DG180-S - DigiSender® xSender™ - Single Input 2.4GHz Wireless AV Sender System
Installing your DigiSender®
continued...
Note: Try to avoid positioning the Transmitter directly on top of other electrical devices as this could
lead to a poor picture.
What’s the A/B switch for?
The Contrast (A/B) switch is present to com-
pensate for differences in equipment set-ups.
If you experience a
poor picture after
installation is
complete, try
adjusting the
A/B setting.
Connect the Power Supply Unit (PSU) to the socket
labelled ‘POWER’ on the rear of the Transmitter.
5.