Troubleshooting guide

Page 12 Please read the instructions carefully prior to installation
DGXDSDV112 - DigiSender® XD HDMI - Single Input HDMI AV Sender System
Turn on both the DigiSender® Transmitter and Re-
ceiver.
1.
Press and hold the ‘Pair’ button on the back of the
DigiSender® Transmitter and Receiver, simultane-
ously, for 5 seconds and then release.
2.
Should you need to re-sync the DigiSender® Transmitter and Receiver at any point, this can be achieved
by following the instructions below.
Using your DigiSender® XD HDMI
Re-syncing the Transmitter and Receiver
Please note that because you need to hold the ‘Pair’ Button on the DigiSender® Transmitter and Receiver
simultaneously, you will need to have both units in the same room as each other and within reach. Al-
ternatively, if you have someone that can help, they can hold the Transmitter ‘Pair’ button in the lounge
while you hold the Receiver ‘Pair’ button in the bedroom.