Troubleshooting guide
Page 10 Please read the instructions carefully prior to installation
DGXDSDV112 - DigiSender® XD HDMI - Single Input HDMI AV Sender System
continued...
Note: When switching from Test Mode to Normal mode, or vice versa, it will be necessary to turn the
unit off and then back on again.
Having made any necessary adjustments to the po-
sitioning of the units and/or aerials, flick the Mode
Switch from Test to Normal and turn the unit off.
Installation is now complete!
12.
The second number indicates Frame Loss. This
is the percentage of Frames that are not getting
through to the DigiSender® Receiver correctly. If you
are getting high Frame Loss you may need to adjust
the positioning of the units and/or aerials.
9.
‘P’ means that the picture quality should be good,
with the Frame Rate remaining steady at around
25. ‘F’ means that you may notice subtle losses in
picture quality due to Frame Loss. Try adjusting the
positioning of the units and/or aerials.
10.
The last icon indicates Signal Level. This is key to a
good Frame Rate and low Frame Loss. Endeavour to
keep this as high as possible. If you are getting a low
Signal Level, you may need to adjust the positioning
of the units and/or aerials.
11.