090608-4 MODEL: DG44RX DigiSender® X7 Additional Wireless Receiver IMPORTANT: ALWAYS KEEP THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE Functions of this product are covered by one or more patents.
DG44RX DigiSender® X7 Additional Receiver STEP 1 - Install the DigiSender™ X7 Additional Receiver Once set up correctly, this additional Receiver will allow you to receive the Satellite, Cable, Freeview, DVD or VCR signals being transmitted by your existing DigiSender® X7 system, on another TV in your home. STEP 1 STEP 2 Place the DigiSender® Receiver on a flat surface near to your additional television. Avoid placing the Receiver directly on top of other electrical devices such as the TV.
DG44RX DigiSender® X7 Additional Receiver continued... Did you know? The DigiSender® Receiver can be connected to a Hi-Fi using the Left & Right Audio outputs on the rear of the unit. Phono cable may be required. STEP 4 STEP 5 Connect the 9V DC Power Supply Unit (PSU) to the socket labelled PSU. Connect the PSU to an available mains socket. STEP 6 Press the POWER button on your DigiSender® Remote Control to switch the Receiver on.
DG44RX DigiSender® X7 Additional Receiver STEP 2 - Day to day usage This DigiSender® X7 additional Receiver functions in the same way as your original DigiSender® X7 Receiver. STEP 1 STEP 2 Switch on the source equipment such as your satellite receiver or DVD player. Select the SCART channel on your additional TV using the televisions Remote Control. Look for a button labelled AUX, AV, VIDEO, VCR or .
DG44RX DigiSender® X7 Additional Receiver TROUBLESHOOTING RemoteRelay™ If you have any difficulty operating your source equipment (Satellite, Freeview, DVD or VCR) in your second room please follow the advice below: 1) Ensure the IR Systeme Technik™ DigiEye™ Remote Control Emitter is connected to the DigiSender® Transmitter. 2) Ensure you are using the correct Remote Control in the second room.
DG44RX DigiSender® X7 Additional Receiver Frequently Asked Questions (FAQ) & Technical Support Q: A: Q: A: My DigiSender® Remote Control has stopped working You need to replace the Remote Control batteries. It takes a CR2025 battery, available from most electrical outlets. Some electrical equipment may interfere with the Remote Controls operation. Move the DigiSender® Transmitter and Receiver away from other electrical devices and keep cables neat and tidy.
RECEIVER SPECIFICATIONS: Remote Relay Transmitter Audio/Video Frequency Modulation Video Output Level Sensitivity Audio Output Level Audio Bandwidth Output Connectors Power Source 433.92MHz 2.4000GHz ~ 2.4835GHz FM 1V PP/75Ω -80dBm 1.0V PP (Mod 1KHz, Dev 15KHz) 10Hz - 22KHz (-1dB) Euro SCART DC Approvals See Declaration of Conformity Antenna System Internal Omni-directional dipole (2.4GHz) Omni-directional dipole (433.
