User's Manual

5
12
VISITOR CODES (FOR OUTPUT 1 ONLY) (Locations 5)
The Visitor Codes are temporary codes for operating Output 1 only. They can be programmed as one
time codes or codes with valid time limit. The Visitor Codes will be cleared automatically after use if
they are one time codes, or, when the allowed time expires.
VISITOR ID
10 Visitor Codes can be programmed. They are represented by an
ID Number of
0
to
9
.
VALID TIME
The time codes in this box MUST be two digits.
00
--- One Time Code
One Time Code has no time limit but it can only be used for ONCE.
It is cleared by the system automatically after use.
--- Time Limit in Hour(s)
The Visitor Code can be set with valid time limit of 1 Hour to 99 Hours with a
two digit time code of 01 to 99. The visitor code is cleared by the system when
the time limit reaches.
VISITOR CODES
The Visitor Codes can be 4-8 digits.
When a new Visitor Code is keyed in an ID box and conrmed, the old Visitor Code in that box is
erased
To delete a Visitor Code from its ID box ---
5 #
PERSONAL SAFETY AND SYSTEM LOCK-UP (Location 6)
LOCK-UP MODES
The Code Entry for the Lock-up Mode:
1
2
0
--- After 10 successive false User Code trials, the keypad locks during 30 seconds.
-- (Default)
--- After 10 successive false User Code trials, the keypad locks during 15 minutes.
Remark: Both of the above lock-ups can be released with the Super User Code at anytime.
Example : To release the lock-up
--- Disappearance of all the above lock-up securities.
4-8 DIGITS
5 #
VISITOR CODE VALIDATIONLOCATION VISITOR ID VALID PERIOD
VALIDATION
#
1
,
2
or
0
LOCK-OUT MODESLOCATIONS
6
SUPER USER CODE
#
0 to 9
01 to 99
0 to 9
00
or
01 to 99
THE CIRCUIT BOARD
Selection of high or low beep
FCC ID: OGJ-DK2310
FCC ID Label & Location