User's Manual

4
INSTALLATION
DK-2310
• Place the keypad outside that is convenient to reach but far from metal structure
• The location for the keypad must be within the receiving range of the receiver
• Open the box by loosing the screws of the xing frame with the supplied hex screw wrench. Take
the circuit module (xed on the faceplate) out carefully
• Fix the back box on wall with the screws supplied
• Snap the battery clip on the 9V alkaline battery and put it in the battery compartment
• Put the circuit module back to the box carefully. Push it in tightly and hold it to prevent drop-out.
• Put the xing frame back to the box. Make sure the rubber gasket is in the right position in the
frame for weatherproof shielding
• Secure the frame tightly on the box with the two screws at the bottom side. Fix them tightly with
the wrench.
Plastic Back Box
with Battery Case
Faceplate +
Circuit Module
Fixing Frame
DER
REBMA
FIXING SCREWS
13
USER CODE ENTRY MODE - Auto or Manual Mode (Location 7)
USER CODE ENTRY MODES
Two entry modes are available for owner’s selection.
1
--- Auto Entry Mode -- (Default)
2
--- Manual Entry Mode
PACIFIER TONES ON-OFF SELECTION (Location 8)
PACIFIER TONES FUNCTION MODES
The Pacier Tone is the Beep Tones from the keypad, which include the tones of Successful Key entry (1
beep), Successful User Code entry (2 beeps) and the Unsuccessful User Code entry (5 beeps).
NOTE : The beeps for Power-up Delay do not belong to pacier tone and can not be OFF.
1
--- Pacier Tone Partially ON – (Default)
2
--- Pacier Tone ON
0
--- Pacier Tone OFF
The keypad checks the User Code automatically when the number of digits is reached. It is
not required to press of the
#
key to conrm. In auto entry mode, the User Codes MUST be
set in the same digit length of the Master Code. For example, if the Master Code is 4 digits,
then all User Codes are also 4 digits. Good for public access control.
Only the Pacifier Tones for Successful Code (2 beeps) and the Unsuccessful User Code
entry (5 beeps) are available. The key entry pacier tone is disabled for power saving.
All the Pacier Tones available from the keypad are enabled. This mode is only good for low
trafc entry/exit usage due to higher power consumption.
All the Pacier Tones are OFF. Good for power saving and silent environment.
Manual Entry Mode always requires the
#
key to follow the User Code for code checking.
The User Codes can be 4-8 digits and they are NOT required to set in the same digit length
with the Master Code. Manual Entry increases the level of security in code trial.
VALIDATION
#
1
or
2
ENTRY MODESLOCATIONS
7
VALIDATION
#
1
,
2
or
0
FUNCTION MODESLOCATIONS
8