User manual

Page 23
Revision 1.1
AEI Intelligent Technologies
CHAPTER 7. Regulatory
FCC CLASS B NOTICE
The equipment complies with Class B Part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1) The device may not cause harmful
interference, and 2) This equipment must accept any interference received,
including interference that may cause undesired operation.
The equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. The equipment generates, uses and can radiate radio-frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If the
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for assistance.
Do not make mechanical or electrical modifications to the equipment.
Caution
— If the device is changed or modified without the permission of
AEI, the user may void his or her authority to operate the equipment.
CE NOTICE
The CE mark on this equipment indicates that this equipment meets or exceeds
the following technical standards: EN55022:1998, EN55024:1998, and
EN60950:1992.