User manual

Page 14
Revision 1.1
AEI Intelligent Technologies
SAFETY PRECAUTIONS
WARNING
-
The adapter is being installed in a system that
operates with voltages that can be lethal. Before you remove
the cover of your system, you must observe the following
precautions to protect yourself and to prevent damage to the
system components.
• Remove any metallic objects or jewelry from your hands and
wrists.
• Make sure to use only insulated or non-conducting tools.
• Verify that the system is powered OFF and unplugged
before accessing internal components.
• Installation or removal of adapters must be performed in a
static-free environment. The use of a properly grounded
wrist strap or other personal antistatic devices and an
antistatic mat is strongly recommended.
PRE-INSTALLATION CHECKLIST
1. Check AEI’s web site at
http://www.aei-it.com for the latest driver and
documentation updates.
2. Check that your server meets the hardware and software requirements
listed under "System Requirements” above.
3. Verify that your system is using the latest BIOS.
4. If installing adapter Software from CD-ROM or floppy, enter the path
where the adapter Software is located on your system.
5. If your system is active, shut it down.
5. When system shut down is complete, power OFF and unplug your system.
6. Holding the adapter card by the edges, remove it from its shipping
package and place it on an antistatic surface.
7. Check the adapter for visible signs of damage (The card’s edge connector
or J1/J2 connectors, RJ-45 or other external connectors). Never attempt
to install any damaged adapter. If the adapter is damaged, report it to AEI.