Troubleshooting guide

Rev. 1.0
- 15 -
HP P100 NIC Instructions
1. Either email driver to machine or put on dat and read driver from this
source.
2. tar -xvf "file name"
3. Open SAM
4. Click on “software management”
5. Click on “install software to local host”
6. Get software... change to “local directory” and change path to” /HP”
7. Under actions, select “install (analysis)”
8. After that is done select ok, and then yes, yes
9. It'll install now and then click yes to reboot
10. After reboot do a lanscan to see if both devices are listed (lan0 and
pfe1) (Ref lanscan instructions, page 18)
11. cd /etc
12. cd rc.config.d
13. vi netconf
(Ref. vi instructions, page 12)
14. edit this file.. change lan0 to pfe1 and then save file, “ :wq!”