SWD81800G1 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CARE AND CLEANING . . . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features.
www.aeg.com • • • • or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover (If the lamp cover is foreseen) of interior lighting. This appliance is heavy. Care should be taken when moving it.
ENGLISH ble regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat ex- 5 changer. The materials used on this appliance marked by the are recyclable. symbol 2.
www.aeg.com Refer to "Daily use - Wine Arrangement". After a power failure the set temperature remains stored. 2.5 Light Button If you want to maintain the light on with the door closed, it is sufficient to open and close the door and the light will remain ON automatically for 10 minutes. If you want to switch off the light before the automatic turn off time, open the door and press the light button. The light has no negative effect on the quality on the wine. 2.
ENGLISH 7 3.2 Wine arrangement Top Compartment: The temperature can be adjusted between +6 and + 11°C. This compartment is ideal for wines, especially new reds and whites, to be consumed immediately. Operation compartments with differentiated temperatures. Bottom Compartment: The temperature can be adjusted between + 11 and + 18°C. This compartment is ideal for storing and refining red or white wines for long periods. The temperatures of this compartment are suitable for storing aged and fullbodied wines.
www.aeg.com 3.4 Wine Cellar shelves Remove the shelves for cleaning. 3.5 Wine Cellar Bottle Holder Remove the shelf and insert it between the two guides. The maximum possible weight on the bottle shelves is 30 kg. The bottom compartment is fitted with a basket useful for placing upright and sloping bottles.
ENGLISH 9 3.6 Humidifier The right humidity is vitally important for the proper storage of wine. Your Wine Cellar is fitted with a special humidifying device that increases the humidity inside the appliance. Spread out the lava stones provided along the small tray as show in the picture. Then fill the tray with water up to the half of its capacity. In normal operation, the lava stones are regularly humidified by the water, periodically check at water present inside the tray and refill it when needed.
www.aeg.com • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply.
ENGLISH 11 5. WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Problem Possible cause Solution The appliance does not operate. The lamp does not operate. The appliance is switched Switch on the appliance. off. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly.
www.aeg.com Problem Possible cause Solution Products prevent that wa- Make sure that products ter flows into the water do not touch the rear collector. plate. Water flows on the ground. The melting water outlet Attach the melting water does not flow in the evap- outlet to the evaporative orative tray above the tray. compressor. The temperature in the appliance is too low. The temperature regulator is not set correctly. Set a higher temperature. The temperature in the appliance is too high.
ENGLISH 13 Remove the lamp cover by pressing it inwards with a tool (e.g. screwdriver) to free the rear side hookings. At the same time, free the middle hook and slide off the cover in the direction of the arrows. Replace the used lamp with a new lamp of the same type and specifically designed for household appliances and having the same characteristics. Install the lamp cover. Connect the mains plug to the mains socket. Open the door. Make sure that the lamp comes on. 5.2 Closing the door 1. 2.
www.aeg.com 6. INSTALLATION 6.1 Positioning A B WARNING! If you are discarding an old appliance that has a lock or catch on the door, you must ensure that it is made unusable to prevent young children being trapped inside. The appliance shall have the plug accessible after installation.
ENGLISH 13 amp ASTA approved (BS 1362) fuse must be used. WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. 6.3 Ventilation requirements 5 cm The airflow behind the appliance must be sufficient. min. 200 cm2 min. 200 cm2 6.4 Installing the appliance 15 Do the following steps: CAUTION! Make sure that the mains cable can move freely. Apply the adhesive sealing strip to the appliance as shown in figure.
www.aeg.com Install the appliance in the niche. Attach the appliance to the niche with 4 screws. Fix the covers on the screws. Do a final check to make sure that: • All screws are tightened.
ENGLISH • The sealing strip is attached tightly to the cabinet. 17 • The door opens and closes correctly. 6.5 Assembly instructions for the compensator lower part of the door With the door open, loosen the two screws situated in the lower part without unscrewing them completely. Position the steel compensator as indicated in the figure and insert the upper part under the head of the screws. Align the compensator with the steel door panel and tighten the screws.
www.aeg.com 7. NOISES There are some sounds during normal running (compressor, refrigerant circulation).
ENGLISH BLUBB! BLUBB! CRACK! CRACK! 8. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 9. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
222354132-A-172012 www.aeg.
