User guide

4
4 INSTALLATION
1. Locating the base unit (See P2 and P3)
The base unit should be placed on a level surface, in a position where:
tthe telephone line cable will reach your telephone line socket or extension socket.
tit is not close to a sink, bath or shower, or anywhere else where it might get wet.
tit is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs,
fluorescent lights, etc.
2. Plug the coiled handset cord into the handset. Plug the other end into the jack on the left side of
the base unit.
3. Place the handset in the base unit.
4. Plug one end of the telephone line cord into the jack at the back of the base unit and the other end
into the modular wall jack.
5. Lift the handset and check for dial tone in the handset.
5 TELEPHONE OPERATION
5.1 Making a call
tLift the handset, listen for a dial tone.
tDial the telephone number.
tTo end the call, return the handset to the base unit.
5.2 To answer a call
tLift the handset to answer a call.
5.3 To end a call
tReplace the handset on the base unit.
5.4 Last number redial
tLift the handset.
tPress the redial button
.
>The phone automatically dials the last number you called (maximum of 32 digits).
5.5 Mute function
tDuring a call press and hold the mute button
.
>When the microphone is muted, the person at the other end of the call cannot hear you but you
can hear his side.
tTo get back to the call, release the mute button
.
5.6 Use on PBX
If you are using your Style 10 phone on a PBX and the PBX user guide tells you to press flash:
tPress the recall button
on your phone.