User manual

Change to menu “Network & Security” and specify IP-address, Gateway and Subnet mask

to the CS121-adapter.

Figure 6: HTTP - Network & Security Settings

Apply your settings with the button at the right side.

Change to menu “Save Configuration” and click “Save Configuration”.

2.1.2 Using Telnet / MS-HyperTerminal

2.1.2.1 Building up a connection

Use of Telnet, enter the command: „telnet <IP-Address>“, whereas <IP-Address> is in the

configuration mode set to 10.10.10.10.

Start a Terminalprogram (e.g. MS-HyperTerminal) and ensure that the serial communication

cable for COM2 is connected. To build up the connection, mind the following communication

settings:

Figure 7: Terminal communication settings

Please confirm this window with OK when you have done all settings. The Terminal is now

ready for communication with the SNMP-adapter and the main menu will start after the

password has been entered. (Default password is “cs121–snmp”).

Note: The number of password-characters is limited in Telnet. Please do never

use a password longer than 15 characters if you intend to use the

configuration via Telnet!

Adapter

Baud rate 9600

Data bits 8

Parity None

Stop Bits 1

Flow Control

Xon/Xoff

None

Handshaking None

CR/LF OFF

Local Echo OFF

Terminal Type ANSI (VT100)