User manual

2. Connect the wire coloured blue to
the terminal either marked with the
letter “N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
(E) is secure over the outer sheath.
Make sure the electricity supply
voltage is the same as that indicated
on the appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse (B). In the event of having to change
the fuse in the plug supplied, a 13 amp
ASTA approved (BS 1362) fuse must be
used.
WARNING!
A cut off plug inserted into a
13 amp socket is a serious
safety (shock) hazard. Ensure
that it is disposed of safely.
3.4 Ventilation requirements
The airflow behind the appliance must
be sufficient.
5 cm
min.
200 cm
2
min.
200 cm
2
CAUTION!
Refer to the assembly
instructions for the
installation.
3.5 Installing the SpinView tray
CAUTION!
Clean the accessory with a
soft moist cloth before first
use. Maximum load allowed
on the tray is 15 kg.
1. Remove the glass shelf from the
fridge.
2. Remove the back trim from the glass
shelf
3. Slide in the SpinView clamps on the
glass shelf back edge.
4. Mount the SpinView tray. Make sure
that the clamp pins fit into special
indentations at the base of the tray.
Check if the SpinView tray is
mounted properly by moving it
gently forwards and backwards.
5. Place the shelf with the clamps inside
the fridge. Push the shelf until the
clamps lock inside the compartment.
ENGLISH
7