EN User Manual Fridge Freezer S83820CTX2 S83820CTW2
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. OPERATION.................................................................................................................... 6 4. DAILY USE.......................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 2.
ENGLISH 2.3 Use WARNING! Risk of injury, burns, electrical shock or fire. • Do not change the specification of this appliance. • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.
www.aeg.com 3. OPERATION 3.1 Control panel 1 2 3 4 5 6 7 8 1 ON/OFF button 2 Top compartment temperature colder button 3 Top compartment temperature warmer button 4 Mode button 5 OK button 6 Bottom compartment temperature colder button 7 Bottom compartment temperature warmer button 8 Display It is possible to change predefined sound of buttons by pressing together Mode button and Temperature colder button for some seconds. Change is reversible.
ENGLISH 3.4 Switching on the fridge To switch on the fridge it is enough to press the fridge temperature regulator. To switch on the fridge in the other way: 1. Press Mode until the corresponding icon appears. The Fridge OFF indicator flashes. 2. Press OK to confirm. The fridge OFF indicator goes off. To select a different set temperature refer to "Temperature regulation". 3.5 Switching off the fridge 1. Press Mode until the corresponding icon appears.
www.aeg.com The DYNAMICAIR indicator is shown. The activation of the DYNAMICAIR function increases energy consumption. If the function is activated automatically, the DYNAMICAIR indicator is not shown (refer to "Daily use"). To switch off the function, repeat the steps until the DYNAMICAIR indicator goes off. 3.
ENGLISH 4.1 Initial power on CAUTION! Before inserting the power plug in to the outlet and switching on the cabinet for the first time, leave the appliance standing upright for at least 4 hours. This will assure a sufficient amount of time for the oil to return to the compressor. Otherwise the compressor or electronic components may sustain damage. 4.
www.aeg.com 5. CARE AND CLEANING WARNING! Refer to Safety chapters. 5.1 Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brandnew product, then dried thoroughly. CAUTION! Do not use detergents or abrasive powders, as these will damage the finish. 5.2 Periodic cleaning CAUTION! Do not pull, move or damage any pipes and/or cables inside the cabinet.
ENGLISH 11 6. TROUBLESHOOTING WARNING! Refer to Safety chapters. 6.1 What to do if... Problem Possible cause Solution The appliance is noisy. The appliance is not supported properly. Check if the appliance stands stable. Audible or visual alarm is on. The cabinet has been recently switched on or the temperature is still too high. Refer to "Door Open Alarm"or "High Temperature Alarm". The temperature in the appliance is too high. Refer to "Door Open Alarm"or "High Temperature Alarm".
www.aeg.com Problem Possible cause Solution The compressor does not start immediately after pressing the FROSTMATIC, or after changing the temperature. This is normal, no error has occurred. The compressor starts after a period of time. The compressor does not start immediately after pressing the COOLMATIC, or after changing the temperature. This is normal, no error has occurred. The compressor starts after a period of time. Water flows inside the refrigerator. The water outlet is clogged.
ENGLISH If the advice does not lead to the desired result, contact the nearest Authorised Service Centre. 13 Only service is allowed to replace the lighting device. Contact your After Sales Service. 6.2 Replacing the lamp The appliance is equipped with a longlife LED interior light. 7. INSTALLATION WARNING! Refer to Safety chapters. A B 7.
www.aeg.com The appliance is supplied with a 13 amp fuse (B). In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. should be placed in the drawer before the appliance is turned on. 1. 2. 3. 4. Open the drawer. Take the filter out of the plastic bag. Insert the filter in the drawer. Close the drawer. 7.
ENGLISH 15
280154201-A-302014 www.aeg.
