Operation Manual

15
ENGLISH
5 FUNCTION (function switch)
6 STANDBY Indicator
7 IR sensor for the remote control
8 VOL+/-buttons
9 PRESETEQbutton
10 SNOOZE button
11 ALARMbutton
12 DISPLAY/ID3 button
13 LCD display
14 PLAYMODEbutton(Repeat/Random play)
15 MEM/CLK-ADJ. button (memory/clock)
16 FOLDER/PRE
(Folder/Preset Up) button
17 TUNE+ / TUNE– buttons (search forward/
backwards)
18
button (play/pause)
19 headphonejack
20
ST/MO button (Stop / Stereo/Mono)
21 (Open/Close) CD compartment
22 CD compartment
Side of unit (not shown)
DC9VConnection
FM ANT. aerial antenna
AUX-IN connection
SPEAKERR/LSpeakerconnections
Subwoofer (not shown)
Operating status indicator
Mains cable
Mainsswitch(POWERON/OFF)
Volumecontrol(SUBWOOFERVOL)
Remote control
1 FUNCTION (function Selection button)
2
(play/pause) button
3 FOLDER/PRE / /i-MENU/i-ENTERbuttons(up/
down, album/ radio memory position / iPod/iPhone
Menu/Enter)
4 +10/-10/i-SCROLL / buttons
5 button (Open/Close)
6 i-REPEATbutton
7 PLAYMODEbutton(Repeat/Randomplay)
8 DISPLAY/ID3 button
9 SLEEP button
10 PRESETEQbutton
11 MUTE button
12 SNOOZE button
13 ALARMbutton
14 i-SHUFFLE button
15 VOL+/-buttons
16 MEM/CLK-ADJ. button (memory/clock)
/TUNE+button(searchforward)
/TUNE– button (search backwards)
(Stop / Stereo/Mono) button
17
/ button
Installation/Introduction
• Readthemanualthoroughlybeforeoperatingthe
device!
• Selectasuitablelocationfortheunitandspeakers.
Suitable locations are dry, even and anti-slip surfaces
on which you may operate the device easily.
• Makesurethereisproperventilationforthedevice!
• Remove,ifnecessary,theprotectionsheetfromthe
display.
Wall mounting
You can also mount the device to the wall (mounting
accessories not supplied).
CAUTION:
Make sure beforehand whether there are cables in the
wallwhichcouldbedamaged!
NOTE: Check the reach of the cable!
To mount the device, make sure that an easily accessible
plug outlet is available within reach of the power cable.
• Aligntheholetemplatehorizontallyandmarkthedrill
holes required for wall mounting.
• Drillthemountingholes.
• Fitrawlplugsandscrewsintotheholes.
• Tightenthemountingscrewsuntiltheyprotrude
around 4 mm from the wall.
• Attachtheunitandspeakersontothescrews.Check
that it is secure.
Assembling the stand
• Inserttheunitandthetwospeakersontothestands
and tighten the mounting screws.