LAVA MAT 2000E combined washing machine/tumble dryer 10 your LAVA MAT 2000 £ combined washing machination dryer you can wash, rinse, spin and dry automatically. The LAVA MAT 2000 E incorporates a special “power economy” programmer for lightly soiled laundry and spins at the very bi speed of 800 rpm. With the AROMATIC spinning system the laundry is regularly loosened up between individual spinning cycles. This is essential for fully automatic washing and drying.
o Lava s050 ¢ a = Selector buttons b = Control lights & = Grip bar of washing powder dispenser d = Door candle | e = Programmer selector and temperature control f = Time selector {drying time) g = Lower front panel {pull this lower front pane down and the drain filter becomes accessible} h = Filter outlet
Preparing the laundry Before commencing washing, we suggest that you sort your foundry into separate piles according to color and type of fabric. When sorting, please check and note the laundry labels on each garment. Remove any foreign bodies from pockets, i e. pins, neediest, paper clips, ete. Close all zips and loosely tie ion apron strings or pajama cords. White fabrics should never be washed with coloreds. If you do, the whites will gradually become Grey.
Starching i you wish to starch laundry in an automatic washing machine, we would point out that the starching effect is only of & mild nature.
1} Programmer selector The programmer selector has 8 settings tor the basic programmed: 1. wash programmer with rewash . short spin automatic SL action) . soaking — extra rewash . pumping With the exception of woolens, you can wash all fabrics with or without rewash, depending on the degree of sailing. The programmer selector must always be rotated in a clockwise direction and only when pushed in. it also serves o switch the machine on and oft, To switch on = put out To switch off = Pugh in 2.
Button m reduced drum Acton By selecting this bunion in conjunction with programmed you reduce the drum action but have a normal water level. In addition, the laundry remains in the last rinse water. Before opening the door, the water must be pumped away. This reduced drum action is suitable for nappies, baby clothes, cotton mixtures or synthetic underwear which do not require a high waterwheel.
Programmer settling Water Washing Programmer Temp. | oo powder Programmer cycle selector Nation control dispenser] 80°— Rewash-main wash at normal water level ABC cooking ~ 5 rinses — spinning 30° Main wash at normal water level cooling rinses ~ spinning o Pr awash-inain wash at normal water level, nets spamming o Main wash al normal water level, max.
Operation Washing Plug the machine in or switch on (if permanently connected). Unless plumbed In, connect the supply hose to the tap, Hook the drain hose over sink edge. Open the water valve Open the outer and inner doors. Load with dry laundry after careful sorting. Close the Inner and outer door. Make sure both doors are shut properly, otherwise the programmer will not start. Pauli out the wash powder dispenser. Add the washing powder and fabric conditioner. Push the dispenser back in.
General notes on drying R Always complete the drying cycle because of the cocking phase. Do not interrupt before the dried laundry has been cooled off. When preparing your drying loads, sort the laundry according to fabric {varying drying times} and the degree of dryness required {ready for storage or ready for ironing). The drying times indicated are approximate values only, they vary with the size of the load, the type of fabric and the absorption properties of the laundry.
Maintenance On completion of the programmer close the water naive, and pull out the plug or simply switch off. Leave the doors open for a while to allow the machine to dry out Remove any washing powder left in the dispenser. if necessary, pull out the dispenser completely. Wipe the outside of the machine with a damp cloth. Follow this with a fast dry cloth, Clean the drain fighter after each wash programmer. To do this, place a flat container on the floor under the filter outlet on the left.
The programmer selector stops during the programmer cycle Your washing machine has been fitted with an AEG Therm o-chron control system, This means that the control knob stops during rewash and main wash until the required temperature is reached. ‘The washing powder foams over Too much washing powder! Reduce the amount of washing powder used in the programmer.
final in your plug, which Is marked with the letter E or by the earth symbol + or colored GREEN, or GREEN and YELLOW. 2. The wire which is colored BROWN must be connected to the LIVE terminal which is marked with the letter L. or colored RED. 3. The wire which is colored BLUE must be connected to the NEUTRAL terminal which is marked with the letter N or colored BLACK.
