EN User Manual Washing Machine L 85275 XFL
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 5 4. CONTROL PANEL...........................................................................................................6 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth.
ENGLISH 2.3 Water connection • Make sure not to cause damage to the water hoses. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.4 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household only. • Obey the safety instructions on the detergent packaging.
www.aeg.com 3.2 How to activate the child safety device To close the door, turn the device anticlockwise until the groove is vertical. This device prevents children or pets from being closed in the drum. 3.3 Fixing plate kit (4055171146) Turn the device clockwise, until the groove is horizontal. You cannot close the door. Available from your authorised dealer. If you install the appliance on a plinth, secure the appliance in the fixing plates.
ENGLISH 4.2 Display A B C D L E K F G J H I The display shows: Temperature of the set programme A Cold water Spin speed of the set programme B No Spin symbol1) Rinse hold symbol 1) Only available for SPIN/DRAIN programme. The phase symbols When a programme is set, all the symbols of the phases related to the programme come on. When the programme starts, only the symbol of the phase in operation flashes. When the programme is completed, the symbol of the last phase is on.
www.aeg.com You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off. F If the programme is completed but the symbol stays on: • The «Rinse hold» function is on. • There is water in the drum. The delay start symbol comes on when you set the delay start function. G Programme time When the programme starts, the programme time decreases with steps of 1 minute.
ENGLISH The extra rinse symbol comes on when this function is activated. K The value shows the total number of the rinses. The indicator bar is fully filled when you set the maximum number of rinses. the Stain symbol comes on when you activate the function. The Prewash symbol comes on when this function is activated. L The indicator bar is not fully filled when you set only one of the functions. The indicator bar is fully filled when you set the two functions. 5. PROGRAMMES 5.
www.aeg.com Programme Temperature range Wool/Silk 40°C - Cold Duvet 60°C - 30°C Anti-Allergy 60°C Spin/Drain3) Rinse 4) Cold Jeans 60°C - Cold 20 min.-3Kg 40°C - 30°C Super Eco Cold Cottons Eco6) 60°C - 40°C Maximum load Maximum spin speed Programme description (Type of load and soil level) 1,5 kg 1200 rpm Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol.2) 2 kg 800 rpm Special programme for one synthetic blanket, duvet, bedspread and so on.
ENGLISH Programme Temperature range Maximum load Maximum spin speed 11 Programme description (Type of load and soil level) Steam programmes7) Steam can be used for dried, washed or worn once laundry. These programmes can reduce creases and odours and make your laundry more soft. Do not use any detergent. If necessary, remove stains by washing or using localized stain removal. Steam programmes do not perform any hygienic cycle.
www.aeg.com Programme options compatibility Extra Silent Delay Start ■ Time Save 3) ■ Cottons Extra Rinse 2) Programme Stains/Prewash 1) 12 ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Synthetics ■ ■ ■ ■ Easy Iron ■ ■ ■4) ■ ■ ■ ■ ■ ■ ■ Delicates Wool/Silk Anti-Allergy Spin/Drain6) Rinse Jeans 20 min.
ENGLISH 6. CONSUMPTION VALUES The data in this table are approximate. Different variables can affect the data: the quantity and type of laundry, the water and ambient temperature. At the start of the programme, the display shows the programme duration for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can be greatly reduced if the laundry load is lower than the maximum load capacity (e.g.
www.aeg.com Off Mode (W) Left On Mode (W) The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 7. OPTIONS 7.1 Start/Pause Press button Start/Pause to start or interrupt a programme. 7.2 Delay Start With this option you can delay the start of a programme from 30 minutes to 20 hours. The display shows the related indicator and delay time. 7.3 Time Save With this option you can decrease the programme duration.
ENGLISH 15 8. SETTINGS 8.1 Acoustic signals The acoustic signals operate when: • You activate the appliance. • You deactivate the appliance. • You press the buttons. • The programme is completed. • The appliance has a malfunction. To deactivate/activate the acoustic and signals, press time for 6 seconds. at the same If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. 8.
www.aeg.com 10.4 Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dispenser. 1 2 CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 10.3 Filling the detergent and additives Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch).
ENGLISH 17 With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on in the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 10.7 Starting a programme with the delay start 10.
www.aeg.com Now, you can set a new washing programme. Before starting the new programme the appliance could drain the water. In this case, make sure that the detergent is still in the detergent compartment, if not fill the detergent again. 10.11 Interrupting a programme and changing a option You can change only some options before they operate. 1. Press button Start/Pause. The related indicator flashes. 2. Change the option set. 3. Press the button Start/Pause again. The programme continues. 10.
ENGLISH Press the button Auto Off to activate the appliance again. The display shows the end of the last set programme. Turn the programme knob to set a new cycle. 19 If you set a programme or an option that ends with water in the drum, the AUTO OFF function doesn't deactivate the appliance to remind you to drain the water. 11. HINTS AND TIPS WARNING! Refer to Safety chapters. Special stain removers are available. Use the special stain remover that is applicable to the type of stain and fabric. 11.
www.aeg.com • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness". 11.5 Water hardness If the water hardness in your area is high or moderate, we recommend that you use a water softener for washing machines. In areas where the water hardness is soft it is not necessary to use a water softener. To know the water hardness in your area, contact your local water authority. Use the correct quantity of the water softener.
ENGLISH 12.6 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 12.7 Cleaning the drain filter Do not clean the drain filter if the water in the appliance is hot. 1. 2.
www.aeg.com 3. 4. 1 5. 2 6. 1 2 7. 8. 1 2 9.
ENGLISH 23 12.8 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 45° 20° 12.9 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
www.aeg.com 13. TROUBLESHOOTING • - The appliance door is open or not closed correctly. Please check the door! 13.1 Introduction • The appliance does not start or it stops during operation. - The mains supply is unstable. Wait until the mains supply is stable. • First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. - No communication between electronic elements of the appliance. Switch off and switch on again.
ENGLISH Problem Possible solution The appliance does not fill with water and drain immediately. Make sure that the drain hose is in the correct position. The hose may be too low. The appliance does not drain the water. Make sure that the sink spigot is not clogged. 25 Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct.
www.aeg.com Problem Possible solution Add more laundry in the drum. The load may be too small. The cycle is shorter than the time displayed. The appliance calculates a new time according to the laundry load. See the ‘Consumption Values’ chapter. The cycle is longer than the time displayed. An unbalanced laundry load increases the duration time. This is a normal behaviour of the appliance. The washing results are not satisfactory. Increase the detergent quantity or use a different detergent.
ENGLISH 27 14.1 Additional technical data Brand logo AEG Name of the distributor Electrolux Lehel Kft 1142 Budapest Erzsébet kir.
132928802-A-472015 www.aeg.
