Specifications

Note on the DIP switch block
Introduction
The DIP switch block is located approximately in the center of the control
board, to the left of the LED bar. The DIP switch block contains a total of 8
miniature switches, located one below the other, which can be set to one of
two positions using a small screwdriver: right (=ON) and left (=OFF).
ATTENTION! The wrong setting can result in destruction of the magnetic
vibrator! Never change the settings of the factory-set lower DIP
switches 3 to 8 without first consulting with AVITEQ Vibrationstechnik.
The factory settings of these switches are given in Table 5-c.
Setting DIP switches 1 and 2
Only change DIP switches. 1 and 2. When making these changes, take care
not to inadvertently change the other switches!
Switches 1 and 2 in the DIP switch block must be set by the customer
according to Tables 5-a and 5-b which follow.
Table 5-a
DIP switch 1 to be set by customer
5.
3
ATTENTION !