Specifications

1 Prerequisites: have the working unit and magnetic vibrator been
completely installed and has wiring of the connector set been finished?
NOTE: It is beyond the scope of this operating manual to predict the
behaivor of vibration devices used with magnetic vibrators and/or
working units not supplied by AVITEQ Vibrationstechnik. If necessary,
contact the manufacturer! AVITEQ Vibrationstechnik is not
responsible for proper functioning of the AVITEQ connector sets when
used together with vibration conveyor devices produced by other
manufacturers!
2 Commissioning must be carried out with smaller working stroke: turn
the vibration-width adjuster (potentiometer) of the connector set to a
dial value of approximately 10%. Or: if external control input (0...10 V
4...20 mA or 0...20 mA) is used, use a control input approximately 10%
on. Now switch on the connector set!
NOTE: Commissioning is carried out using a small working stroke as the
vibra-tional behaivor of the complete vibration conveyor device is, at
this point, still unknown. Damages resultingfrom installation error
can, therefore, be detected in good time. Example: bumping of the
working unit on an adjacent conveyor component or collision mode.
3 Listen for hammering noises! These can occur during collision mode and
lead to the destruction of the drive unit.
4 Reduce the working stroke by decreasing the command value setting
(turn \ the potentiometer to the left or reduce the extraneous command
value) until the hammering noises cease. Reduce the vibrator voltage by
on the control board (type VAE-2) approx. 10° counter-clockwise.
DANGER! Life-threatening voltages! Take suitable precautions (cover
electrically live components) to prevent accidents. Observe regulations
specified by the employer's liability insurance association!
5 The working stroke is increased by rotating the vibration-width adjuster
(potentiometer) in small steps or by increasing the external control
input until the maximum value (right-hand stop or dial value "10" on
the vibration-width adjuster or maximum extraneous command value)
is reached.
NOTE
NOTE
DANGER!