Specifications

5.2 Commissioning with vibrators from Other
Manufacturers
5.2.1 Setting the vibrator Mains Voltage
The vibrator mains voltage 1%, which can be measured at binding posts 3 and 4 on
the connector set, is set with a fixed value at the factory for use with original AVITEQ
devices.
If a magnetic vibrator from another manufacturer is to be used, the setting must be
checked prior to commissioning and, if necessary, adjusted.
NOTE: The vibrator mains voltage can be set by AVITEQ Vibrationstechnik; when
ordering the connector set, let us know what the actual vibrator mains voltage
of the non-AVITEQ device is!
If you would like to set the vibrator mains voltage yourself, carry out the steps in the
following commissioning description.
NOTE: When using vibrators from other manufacturers, only voltage or effective
working stroke regulation (with AVITEQ Vibration Sensor type PA...) is possible.
5.2.2 Commissioning
For the commissioning, we refer you to the commissioning instructions provided by
the manufacturer of your magnetic vibrator.
We recommend the following procedure, which should be in agreement with the
instructions for the non-AVITEQ device (see commissioning flow chart on page 5-5).
NOTE
NOTE