Specifications

5.1 Commissioning with AVITEQ magnetic vibrator
5.1.1 Commissioning Procedure
When commissioning with the original AVITEQ magnetic vibrator, you are advised to
follow the commissioning steps of the appropriate chapter in the magnetic vibrator
operating manual.
In the event of malfunction, refer to Chapter 7 located towards the end of this ope-
rating manual. Addtional information is included in the Troubleshooting Chapter of
the AVITEQ magnetic vibrator operating manual or AVITEQ Vibration Conveyor Device]
operating manual.
5.1.2 Special Notes
Please note that voltage or working stroke regulation cannot be used with some i
magnetic vibrators. To operate with a combined voltage and working stroke regula-j tor,
a vibrator with a built-in vibration sensor is necessary (type MV..-...P).
Voltage regulation is not possible with the following magnetic vibrators:
• MVE 33-1, MVF 33-2, MFC 33-1 and (s)MVH 33-1
These types can only be operated with working stroke regulation.
ATTENTION! Collision mode and damage to the vibrators! Always operate the
above-mentioned magnetic vibrator types with a vibration-width sensor
connected in order to prevent collision mode.
The vibration frequency is set in the factory prior to delivery.
NOTE: Prior to commissioning, check that switch 2 of the DIP switch block is
correctly set (see Chapter 5.3)
DANGER! When the device is connected to mains, dangerously high voltages are
present inside of the Connector Set. Switch off the current supply to the Com
nector Set prior to all work and protect against unintentional reconnectiom
during installation work.
ATTENTION!
DANGER
NOTE