Specifications

4.4 Electrical Connection to the Magnetic
Vibrator
A connection diagram is included with each VIBTRONIC connector set. The
connection diagram is also included in this operating manual in Chapter
4.3.2 (see Figure 4.11).
 Make all the connections between mains, connector set, command
value circuit, and magnetic vibrator.
 When working with the available options, note the device-typical
peculiarities and the applicable binding post assignments chapters
4.2.1 to 4.2.6 shown earlier in this chapter.
DANGER! When the unit is connected to mains, life-threatening
voltages are present inside Ihe connector set. Touching electrically
live components can be lethal! Before switching on mains power,
ensure that no live parts can be touched. Close the cover of the
control case or switch cabinet door(s)!
4.4.1 Electromagnetic Compatibility (EMC)
The connector sets of series SA(E)...-2 were developed and constructed
in confor-mance with EMC directive 89/336/EWG. They fulfil the
requirements of standards EN 50081-2 and EN 50082-2.
ATTENTION! The connector sets are designed in accordance with EN
50081-2 (generic emission) for industrial areas and must not be
used in residental areas.
NOTE: Observe the binding post assignment data given in the
proceeding chapters regarding the shielding of signal lines.
ATTENTION!
DANGER
NOTE