Specifications

Dimensions and measurement inputs are to be taken from Figure 4.14.
Figure 4.14
Actual-value display (dimensions and connection assignments)
Installation Steps
 Switch off the current supply from the installation area and check that no
voltages are present!
 Fit front cutout (30.5 x 57 mm)
 Install display and secure with strap
 Solder connections from rear
 Switch on display and, if necessary, fine-tune with potentiometer PI
NOTE: The rear side of the actual-value display has IP 00 type
protection, the front side has IP 50 type protection. Note tijis when
retrofitting in a switching cabinet or housing.
NOTE