Specifications

NOTE: For Magnetic Vibrators without a vibration sensor and/or temperature

switch, binding posts 13 and 14 must be connected by a wire bridge.

If the bridge is missing, the red LED (HOT/ERROR x) lights up and the

operational message relay opens. As a result, the vibrator voltage at

binding posts 3 and 4 goes to zero; the Magnetic Vibrator ceases to

function.

NOTE: Use only potentiometers (limit values between 1 and 10 kOhm)

with linear characteristics for the vibration-width adjuster Shield the

signal lines to guarantee electromagnetic compatibility if the lines

exceed five metres in length!

4.2.2 Vibration sensor (PAL) and temperature switch

AVITEQ Magnetic Vibrators, series

• MV_S... (with temperature switch) and

• MV_S...P (with temperature switch and vibration sensor)

are fitted at the factory with a flexible, 5-conductor connection cable.



Remove the wire bridge from binding posts 13 and 14.



Connect the two black wires of the connection cable for the

temperature switch and/or vibration sensor to binding posts 13 and 14

(see Figure 4.4).

Figure 4.4

Vibration sensor and temperature switch (binding posts 13 and 14)

NOTE