Specifications

3.4 Series and Models
3.4.1 Series
Three series of VIBTRONIC connector sets with various characteristics are
available:
• Type series SU(E)... without voltage regulation in cabinet and panel
mounting units for nominal currents up to 6 A.
• Type series SC(E)... with voltage regulation in cabinet and panel mounting
units for nominal currents up to 14 A.
• Type series SA(E)... with voltage and working stroke regulation in cabinet
and panel mounting units for nominal currents up to 43 A.
NOTE
NOTE: In this operating manual, only the connector sets of series
SA(E)...-2 are covered.
3.4.2 Models
The connector sets are available in the sizes F, G and H in the following
variants:
• Cabinet unit SA... (JP54): enclosed compact housing for securing to
walls or frames. Vibration-width adjuster and mains switch are installed
on the front side of the housing.
• • Panel mounting unit SAE... (IP 00): controller block for installing in the
switching cabinet or in closed control locations
• The corresponding technical data are located in Table 3-a:
Table 3-a
Technical data for Connector Sets SA(E)...-2
SA(E)-FS..-2 SA(E)-GS..-2 SA(E)-HS..-2
Mains frequency 50 or 60 Hz
Vibration frequency with 50 Hz mains 25, 33 1/3 or 50 Hz
Vibration frequency with 60 Hz mains 30 or 60 Hz
Nominal voltage(s) with 50 Hz mains 220...240 V
380... 420V
460...500V
380...420V
460...500V
Nominal voltage(s) with 60 Hz mains 220...240V 440... 480V 440...480V