Specifications

3.1 Introduction
AVITEQ magnetic vibrators must be operated with the appropriate VIBTRONIC
connector sets. Depending on the application and size of the magnetic drive,
AVITEQ Vlbrationstechnik GmbH supplies connector sets from the SA(E)...-2 in
size F, G or H, available in cabinet and panel mounting units.
3.2 Operating Principle
Oscillation rates and mains frequency
Connector sets of type SA(E)...-2 are alternating-voltage regulators and function
on the voltage regulation principle (phase regulation).
• Connector sets for vibration conveyor devices with an oscillation rate
of 1,500 min"
1
(25 Hz) at a mains frequency of 50 Hz and 1,800 min"
1
(30 Hz) at a mains frequency of 60 Hz fire every fourth mains half-wave.
• Connector Sets for vibration conveyor devices with an oscillation rate
of 2,000 min'
1
(33 1/3 Hz) with a mains frequency of 50 Hz fire every
third mains half-wave.
• Connector sets for vibration conveyor devices with an oscillation rate
of 3,000 min"
1
(50 Hz) at a mains frequency of 50 Hz and 3,600 min"
1
(60 Hz) at a mains frequency of 60 Hz fire every second mains half-
wave.
The mechanical vibration frequency (25,30,33 1/3, 50 or 60 Hz) is set at the fac-
tory prior to delivery and is encoded in the type designation.
NOTE
NOTE: This new generation of connector sets was designed with the EMV
directive (89/336/EWG) in mind and meets the requirements of EN
50081-2 and W50082-2.
NOTE
NOTE: Oscillation rates are given in "min'
1
" and the vibration frequency
in"Hz".