Specifications

1.3 Fields of Application
VIBTRONIC connector sets, types SA...-2 and SAE...-2, hereafter abbreviated
with SA(E)...-2, allow infinite adjustment of the working stroke on the magnetic
vibrator and thereby of the conveyor rate from vibration conveyor devices.
The connector sets must be used together only with AVITEQ magnetic vibrators or
corresponding magnetic vibrators from other manufacturers in accordance with
their intended use. Information in the vibration conveyor device operating
manual is also to be observed!
The connector sets must only be operated with magnetic vibrators from other
manufacturers when their connection specifications are identical to those of the
AVITEQ magnetic vibrators. For more information, see Chapter 5.2!
There are no other intended uses for the connector sets.
Never attempt the following:
• Do not use in environments with explosion hazards (explosives, pit gas envi-
ronments, hazard of dust explosion)! The units are not protected against
explosions!
• Do not use at ambient temperatures below -25 and over +40 °C (cabinet
unit) and + 50 °C (panel mounting unit), or in tropical climates or areas where
dew or condensation could form! The units are designed for operation in
moderate climatic environments (DIN IEC 721)!
• Do not use together with magnetic vibrators which are not compatible with the
connector sets!
• Do not use mains networks and mains frequencies other than those for
which the connector sets were designed!
• Do not use at altitudes exceeding 1,000 m above sea level! The connector
set is not designed for high altitudes. Contact us if you have questions!
Connecting to Mains and Magnetic Drives
Only AVITEQ connector sets connected to a sinusoidal mains network may be
used for operating the AVITEQ Magnetic Drives. For each AVITEQ Magnetic Drive
model there is a corresponding connector set.
Other control and connection options are not included.