Operating instructions

Procedure for programming the manageable outputs

Step 1:

First set the UPS to the so-

called standby

operating mode, i.e. if the UPS was just in

operation, switch it off. ATTENTION: Your

connected electrical loads are de-energised

by this! Also ensure that the internal/external

battery's contacts were connected properly.

The liquid crystal display should generally

show the content shown here.

Step 2:

You can access the UPS setup menu by

pressing and holding the "SELECT" button

for at least 5 seconds.

"01" appears in the

"SET" display window.

Step 3:

Navigate to menu item "02" with the "▼" or

"▲" button. Now confirm with the "ENTER"

button. You will be brought to the selection

window of parameter 2: Select between

"dis"able and "ena"ble here. Then press

either the "▼" or "▲" button again and select

"ena"ble.

Confirm your selection with

"ENTER".

Step 4:

Now navigate to menu item "03" with the

"▼" or "▲" button. After confirming with

"ENTER" again, you can now specify the

setting of the desired switch-

off time in

minutes in battery mode ("▼" or "▲"). Fi-

nally, confirm with "ENTER" once again.

Step 5:

Setup is now complete. You can exit the setup menu by selecting menu

item "00", i.e. navigate to "00" with "▼" or "▲", and confirm again with the

"ENTER" button. The liquid crystal display should now in principle

correspond with the display from Step 1 again.

Step 6:

Disconnecting the UPS from the mains will then save the changes to the

UPS internal memory. Wait until the liquid crystal display goes out.