Technical data

Selection and Installation of the Controller – VIBTRONIC controllers
4–2
l
the simpler controller of type SW... for the smaller conveyor units
l
the voltage-regulated version of type SC... with soft start and compensation
for mains voltage fluctuation influence on the throughput
To coordinate conveyor systems in assembly and handling applications, special
components are required that control the units. You can find further information on
these special applications in the brochure „Sorting and conveying equipment“,
which is available from AViTEQ Vibrationstechnik. Further controllers are available
on request.
4.2.2 Type designation
The significance of the type designations of the VIBTRONIC controllers is shown
by way of an example in the following figure, here for controllers without voltage
regulation.
The material overflow watchdog, if it is part of the shipment, is described in an
appendix supplied.
Figure 4.1 Explanation of the type designators on VIBTRONIC controllers
Example for controllers without voltage regulation:
SUE-B50-1/TUK . . .
SU controller, unregulated in housing
SW resistance controller without soft start
SC controller with voltage regulation
SUE open version IP 00
50 vibration frequency: 50=3.000 min
-1
( 50 Hz)
100 100=6,000 min
-1
(100 Hz)
B,C version designator: A=0,1 A, B=3 A, C=6 A
TUK material overflow watchdog
NOTE