Technical data

Operating Manual for AViTEQ Small Conveyor Units KF and KR

3–7

3.2 Mounting the small conveyor unit on the

base plate

If the small conveyor unit with storage container (optional) was delivered by AVi-

TEQ in a pre-assembled state, the following installation steps refer to the attach-

ment of the structure comprising small conveyor unit, working unit, storage contai-

ner and possibly a rattler, to the base plate. No additional rubber feet are required.

Only the complete small conveyor unit, i.e., the small conveyor drive and the wor-

king unit attached, is bolted onto the base plate or the support structure.

Base plate or support resonances may impair functionality and cause damage.

Ensure that the construction of the base plate or support structure is stiff enough to

resist oscillation!

3.2.1 Before installation

Put the small conveyor drive onto a solid and flat base plate!

Damage to the small conveyor units or unsatisfactory throughput may result from

installation with an incorrect orientation! AViTEQ small conveyor units are suitable

for horizontal installation only. The deviation from horizontal position must not ex-

ceed 8°! The resting points of the feet must be on a plane, steps are not permitted.

AViTEQ offers a special version for suspended operation. Use this version only!

Have the mounting bolts for the small conveyor unit ready. Ensure that the

bolts have the correct length (cf. Table 3.9 on page 10)!

F The controller must be separated from the mains if it has already been con-

nected to the small conveyor drive.

If there is insufficient support, the conveyor may fall off the assembly table and,

under the worst circumstances, cause injuries. You should therefore pay attention

to a safe support!

F Follow the installation steps shown in the diagram (cf. see Figure 3.7 on page

8) and read the explanations associated with each step. This procedure will

simplify the assembly for you!

NOTE

ATTENTION!

NOTE

DANGER!