Technical data

Operating Manual for AViTEQ Small Conveyor Units KF and KR

2–3

Cardboard containers and paper packing tapes can be recycled within the RESY

Disposal and Re-utilisation System. Where used, packaging foil, packing tapes,

and foam foils are made from polyethylene (PE), the CFC-free cushions are usually

made from polystyrene foam (PS). These packaging materials consist of pure car-

bohydrates and are thus recyclable.

In special cases, we use steel packing bands and wooden cases free of chemical

treatment.

2.3.2 Materials used in the units

AViTEQ accepts used units for free disposal if they are delivered at customers’

expense to AViTEQ Vibrationstechnik GmbH, Frankfurt.

In case of disposal by the customer, and when exchanging components, the cur-

rent local waste and disposal regulations apply and should be observed. AViTEQ

does not accept any responsibility for parts and components that have been dis-

posed of improperly!

The small conveyor drive consists of, among others, the following materials:

Magnet: iron core, copper wire (isolated wire with lacquer), plastic resin

Springs: spring steel or glass fibre reinforced plastic

Housing: base from cast iron or steel, base plate made of cast aluminium and

steel, brass spring washers, and other steel components ( St 37 or VA)

For the disposal of the controller, the regulations for the disposal of electronic

parts and components apply.

The power semiconductors (thyristor and diode modules) used do not contain

beryllium and thus may be disposed of as electronic waste.

If required, AViTEQ is able to supply detailed information on the materials used. In

case of doubt, take advantage of our disposal offer!

NOTE