Contents Page Description When using your new hob units for the first time Power consumption The automatic disc Suitable cooking utensils Connecting and fitting instructions for the electrician Assembly instructions 10 Hob care 10
These operating instructions refer to the range of AEG built-in electric hob units. The number of your model is quoted on the rating piste of the appliance. Please note inch measurements are for guidance only — always use the millimeter or centimeter measurements. Description The hob unit range comprises the following models; one rectangular automatic plate with control automatic plates of 180 mm (7)) dia resp. with control switch. The hobs of this range are all fitted with stainless stew] hob plates.
Operation A control knob with a setting range of 112 is provided for the plate with temperature regulator {models EKE 1 and EKE 2 only). The numbers are subdivided into four groups of thees numbers each, Simmering® 4 i 8 ,Strong beat, boiling" 7 9 ,Heavy boiling, gentle frying” 10 112 .Strong frying” (deep-frying). As a general guide, start with the underlined figure and adjust the setting up or down as necessary.
Being a temperature-controlled plate, it can also be used for automatic cooking, i. e. you can select the required range {simmering, cocking or frying) right from the start. The tons will then reach the set temperature fairly quickly as the temperature regulator maintains full output unit the appropriate temperature is reached. The conventional method, stile preferred by the majority of housewives, is also possible; I e.
Suitable cooking utensils We recommend the use of stainless steel or aluminum pans specially designed for electric cooking: heavy turned or ground base to ensure maximum utilization of the heat at reduced cost. Saucepans with an uneven or wobbly base could ultimately damage the discs through over-heating (see conditions of guarantee.
Dimensions for the installation of two or more built-in hob units or deposit plates.
Connecting two built-in hob units top covering strip = retaining strip underneath screw off) seal 5§ = connecting strip front and back 6 = sheet metal screw iffy AT \ deem ) ==
Assembly instructions Place the hobs side by side with the plates facing down. Loosely screw on the connecting bars — see fig. 5 — using the sheet metal screws provided gee fig. 6. inert the covering strip — see fig. 1 with the seal ~ fig. 4 — between the hob units {from underneath}. Position and loosely screw on the retaining bar — fig. 2 — using the screws provided — see fig. 3. Push the hob units together and tighten the screws of connecting bar and retaining strip.
