User manual

Problem Possible cause Remedy
Hob²Hood operates, but on-
ly the light is on.
You activated the H1 mode. Change the mode to H2 - H6
or wait until the automatic
mode starts.
Hob²Hood modes H1 - H6
operate, but the light is off.
There might be a problem
with the light bulb.
Contact an Authorised Serv-
ice Centre.
There is no sound when you
touch the panel sensor
fields.
The sounds are deactivated. Activate the sounds. Refer to
"Daily use".
Wrong language is set. You changed the language
by mistake.
Reset all functions to the fac-
tory settings. Select Reset All
Settings from the Menu.
Disconnect the hob from the
electrical supply. After 1 min,
connect the hob again. Set
Language, Display Bright-
ness and Buzzer Volume.
The flexible induction cook-
ing area does not heat up
the cookware.
The cookware is in a wrong
position on the flexible in-
duction cooking area.
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cook-
ware depends on the activa-
ted function or function
mode. Refer to "Flexible in-
duction cooking area".
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Use cookware with a diame-
ter applicable to the activa-
ted function or function
mode. Use cookware with a
diameter smaller than 160
mm on a single section of
the flexible induction cook-
ing area. Refer to "Flexible
induction cooking area".
A cooking zone deactivates.
A warning message saying
the cooking zone is going to
switch off comes on.
Automatic Switch Off deacti-
vates the cooking zone.
Refer to "Daily use".
Deactivate the hob and acti-
vate it again.
and a message come on.
Lock operates. Refer to "Daily use".
O - X - A appears. Child Lock operates. Refer to "Daily use".
blinks.
There is no cookware on the
zone.
Put cookware on the zone.
www.aeg.com22