HC452400EB EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • Do not store items on the cooking surfaces. • Do not use a steam cleaner to clean the appliance. • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. • If the glass ceramic surface is cracked, switch off the appliance to avoid the possibility of electric shock.
ENGLISH • • • • • • pliance or hot cookware, when you connect the appliance to the near sockets Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable or plug (if applicable) can make the terminal become too hot. Make sure that a shock protection is installed. Use the strain relief clamp on cable. Make sure not to cause damage to the mains plug (if applicable) or to the mains cable. Contact the Service or an electrician to change a damaged mains cable.
www.aeg.com • Clean regularly the appliance to prevent the deterioration of the surface material. • Do not use water spray and steam to clean the appliance. • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. • Contact your municipal authority for information on how to discard the appliance correctly. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. 2.
ENGLISH 7 Use the sensor fields to operate the appliance. The displays, indicators and sounds tell which functions operate. sensor field function 1 To activate and deactivate the appliance. 2 To lock/unlock the control panel. 3 To activate and deactivate STOP+GO function. 4 To activate and deactivate the Bridge function. 5 A heat setting display To show the heat setting. 6 Timer indicators of cooking zones To show for which of the cooking zones you set the time.
www.aeg.com 3.4 OptiHeat Control (3 step Residual heat indicator) WARNING! \ \ Risk of burns from residual heat! OptiHeat Control indicates the level of the residual heat. The induction cooking zones make the heat necessary for cooking directly in the bottom of the cookware. The glass ceramic is heated by the heat of the cookware. 4. DAILY USE 4.1 On and Off 4.3 The heat setting Touch for 1 second to start or stop the appliance. Touch the control bar at the heat setting.
ENGLISH 9 12 11 10 9 8 7 6 5 4 3 2 1 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 4.8 The Timer 4.5 Switching the Power function on and off The Power function makes more power available to the induction cooking zones. The Power function is activated for 10 minutes at most. After that the induction cooking zone automatically switches back to heat setting 14. To switch on, , comes on. To switch off, touch . touch a heat setting 4.
www.aeg.com When the timer countdown comes to an end, the sound operates and 00 flashes. The cooking zone deactivates. • To deactivate the sound: touch The Count up timer Use the Count up timer to monitor how long the cooking zone operates. • The selection of the cooking zone (if more than 1 cooking zone operates) : touch again and again until the indicator of a necessary cooking zone comes on. When this function is activated, comes on.
ENGLISH • When you stop the hob with , the Child Safety Device operates again. 4.12 OffSound Control (Deactivation and activation of the sounds) Deactivation of the sounds Deactivate the appliance. Touch for 3 seconds. The displays come on and go out. Touch for 3 seconds. comes on, the sound is on. , comes on, the sound is Touch off.
www.aeg.com • Put cookware on a cooking zone before you start it. 5.4 Öko Timer (Eco Timer) To save the energy, the heater of the cooking zone switches itself off earlier than count down timer signal. The heating time reduction depends on cooking level and cooking time. When you increase the heat setting it is not proportional to the increase of the cooking zone consumption of power. It means that the cooking zone with the medium heat setting uses less than a half of its power.
ENGLISH He at set tin g Use to: Time Hints 14 Boil water, cook pasta, sear meat (goulash, pot roast), deep-fry chips 13 Nominal power consumption 100 % Boil large quantities of water. Power function is activated. 6. CARE AND CLEANING Clean the appliance after each use. Always use cookware with clean bottom. WARNING! Sharp objects and abrasive cleaning agents will damage the appliance. For your safety, do not clean the appliance with steam blasters or high-pressure cleaners.
www.aeg.com 7. TROUBLESHOOTING Problem Possible cause and remedy You cannot activate the appliance or operate it. • You touched 2 or more sensor fields at the same time. Only touch one sensor field. • There is water or fat stains on the control panel. Clean the control panel • Activate the appliance again and set the heat setting in 7 seconds. • The child safety device or the lock or STOP+GO operates. See the chapter Daily use. A sound operates when the appliance is deactivated.
ENGLISH Problem 15 Possible cause and remedy There is no signal when The signals are deactivated. you touch the panel sen- Activate the signals (see OffSound Control ). sor fields. If you tried the above solutions and cannot repair the problem, speak to your dealer or the Customer Care Department. Give the data from the rating plate, three-digit-letter code for the glass ceramic (it is in the corner of the cooking surface) and an error message that comes on.
www.aeg.com 8.4 Assembly min. 500mm min. 50mm min. 2mm R 5mm 55mm min. 12 mm min. 2 mm • Seal the gap between the worktop and glass ceramic with silicone. • Put some soapy water on the silicone. 490+1mm 340+1mm min. 38 mm min. 2 mm • Pull off the excess silicone with the scraper.
ENGLISH 17 8.5 The installation of more than one appliance Added parts:connection bar(s), heat resistant silicon, rubber shape, sealing strap. + 360 mm - 20 mm = 920 mm 490 mm 520 mm 580 mm Only use special a heat - resistant silicon. The worktop cut out Distance from the wall : minimum 50 mm Depth : 490 mm Width : sum widths of all the appliances to be built-in and subtract 20 mm (see also "Overview of all appliance widths" ) The installation of more than one appliance 1.
www.aeg.com 9. Seal the gap between the worktop and appliances and between appliances with silicone. 10. Put some soapy water on the silicon. 11. Press the rubber shape with some strength against the glass ceramic and move it slowly along the space. 12. Do not touch the silicon until it be- come hard, it can last about a day. 13. Carefully remove silicon that came out with a shaving blade. 14. Clean glass ceramic fully. 9. TECHNICAL INFORMATION Model HC452400EB Prod.Nr.
ENGLISH document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1. In this warranty a) ‘acceptable quality’ as referred to in clause 10 of this warranty has the same meaning referred to in the ACL; b) ‘ACL’ means Trade Practices Amendment (Australian Consumer Law) Act (No.
www.aeg.
ENGLISH 21 FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL customercare@aegaustralia.com.au For the cost of a local call (Australia only) FOR SPARE PARTS or to find the address of your nearest state spare parts centre in Australia PLEASE CALL 13 13 50 OR EMAIL customercare@aegaustralia.com.
www.aeg.
ENGLISH 23
892958355-B-132013 www.aeg.
