User manual

There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously and
until the indicators ,
, and flash and
the display is blank.
2. Press
.
• The indicators
, and
are off.
• The indicator
still
flashes.
• The display shows the current
setting:
– = Acoustic signal off.
– = Acoustic signal on.
3. Press
to change the
setting.
4. Press on/off to confirm the setting.
6.5 AirDry
AirDry improves the drying results with
less energy consumption.
During the drying phase, the
door opens automatically
and remains ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
opening. This can cause
damage to the appliance.
AirDry is automatically activated with all
programmes excluding .
To improve the drying performance refer
to the XtraDry option or activate AirDry.
CAUTION!
If children have access to the
appliance, it is advised to
deactivate AirDry as opening
the door may pose a danger.
How to deactivate AirDry
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously and
until the indicators ,
, and start
flashing and the display is blank.
2. Press .
•
The indicators , and
are off.
• The indicator still flashes.
• The display shows the current
setting: = AirDry activated.
3. Press
to change the setting:
= AirDry deactivated.
4. Press on/off to confirm the setting.
www.aeg.com
10