FFE83800PM USER MANUAL EN User Manual Dishwasher
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION...........................................................................................6 4. CONTROL PANEL....................................................................................................... 7 5. PROGRAMMES...
ENGLISH 3 damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean the appliance. The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. The ventilation openings in the base (if applicable) must not be obstructed by a carpet. Some dishwasher detergents are strongly alkaline.
ENGLISH new devices fitted (water meters, etc.), let the water flow until it is clean and clear. • Ensure that there are no visible water leaks during and after the first use of the appliance. • The water inlet hose has a safety valve and a sheath with an inner mains cable. 5 • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. 2.5 Internal light WARNING! Risk of injury.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 12 11 10 9 8 7 1 2 3 4 5 6 7 6 Top spray arm Upper spray arm Lower spray arm Filters Rating plate Air vent Rinse aid dispenser 3.1 TimeBeam The TimeBeam is a display that is shown on the floor below the appliance door. • When the programme starts, the programme duration comes on. • When the programme is completed, 0:00 and CLEAN come on. • When the delay start starts, the countdown duration and DELAY come on.
ENGLISH When AirDry is activated during the drying phase, the projection on the floor may not be completely visible. To check the remaining time of the running programme, look at the control panel display. 4. CONTROL PANEL 2 1 1 2 3 4 5 On/off button Display Program touchpad Delay touchpad MyFavourite touchpad 4 3 6 7 8 9 5 6 7 8 TimeSaver touchpad XtraDry touchpad ExtraHygiene touchpad Indicators 5.
www.aeg.
ENGLISH Programme 1) Water (l) Energy (kWh) Duration (min) P5 14 - 16 1.2 - 1.5 160 - 180 P3 12.5 - 14.5 1.4 - 1.7 170 - 190 P6 12 - 14 0.7 - 0.9 82 - 92 P4 10.5 0.7 38 P8 4 0.01 14 P7 9.0 - 10.0 1.1 - 1.3 230 - 250 9 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.
www.aeg.com To enter user mode, press and hold simultaneously and until the indicators , , , and and the display is blank. flash Factory setting: level 4. 6.2 The rinse aid empty notification The rinse aid helps to dry the dishes without streaks and stains. The rinse aid is automatically released during the hot rinse phase. When rinse aid chamber is empty, the rinse aid indicator is turned on notifying to refill rinse aid.
ENGLISH 3. Press the on/off button to confirm the setting. 6.5 How to set the colour of the TimeBeam The appliance must be in programme selection mode. It is possible to change the colour of the TimeBeam to match the colour of the kitchen floor. There are several colours available. The TimeBeam can also be deactivated. Make sure the appliance is in user mode. 1. Press , , and still flashes. • The indicator • The display shows a number and letter C. Each number refers to a different colour.
www.aeg.com How to set the MyFavourite programme • If options are saved together with the programme, the indicators related to the options are on. . Press • The MyFavourite indicator is on. • The display shows the number and the duration of the programme. 7. OPTIONS Desired options must be activated every time before you start a programme. It is not possible to activate or deactivate options while a programme is running. Not all options are compatible with each other.
ENGLISH not come on or it flashes quickly for a few seconds and then goes out. 13 The display shows the updated programme duration. 8. BEFORE FIRST USE 1. Fill the rinse aid dispenser. 2. Open the water tap. 3. Start a program to remove any processing residuals that can still be inside the appliance. Do not use detergent and do not load the baskets. 8.1 How to fill the rinse aid dispenser A B 1. Open the lid (C). 2. Fill the dispenser (B) until the rinse aid reaches the marking ''MAX''. 3.
www.aeg.com CAUTION! Use only a detergent specifically designed for dishwashers. To ensure correct unlocking, lift the release handle completely and the basket slightly until the basket is disengaged on both sides. There are two ways of lowering the basket depending on the loading: • If there is a full load of plates slightly push the basket down. • If the basket is empty or halfloaded press the basket down. 9.
ENGLISH Starting a programme 1. Keep the appliance door ajar. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. 3. Press repeatedly until the display shows the number of the programme you want to start. The display will show the programme number for approximately 3 seconds and then show the programme duration. • If you want to select the MyFavourite programme, press .
www.aeg.com • Do not pre-rinse dishes by hand. When needed, use the prewash programme (if available) or select a programme with a prewash phase. • Always use the whole space of the baskets. • When loading the appliance, make sure that the dishes can be completely reached and washed by the water released from the spray arm nozzles. Make sure that items do not touch or cover each other. • You can use dishwasher detergent and rinse aid separately or you can use the multi-tablets.
ENGLISH 17 11. CARE AND CLEANING WARNING! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty filters and clogged spray arms decrease the washing results. Make a check regularly and, if necessary, clean them. 3. Remove the flat filter (A). 4. Wash the filters. 11.1 Cleaning the filters The filter system is made of 3 parts. C B A 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6.
www.aeg.com CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.2 Cleaning the upper spray arm 4. To engage again the spray arm to the basket, press the spray arm upwards in the direction indicated by the lower arrow and simultaneously turn it counterclockwise until it locks into place. We recommend to clean regularly the upper spray arm to avoid soil to clog the holes. Clogged holes can cause unsatisfactory washing results. 1.
ENGLISH • To maintain the performance of your appliance at its best, we recommend using a specific cleaning product for dishwashers (at least once a month). 19 Follow carefully the instructions on the packaging of the product. 12. TROUBLESHOOTING If the appliance does not start or it stops during operation. Before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table.
www.aeg.com Problem and alarm code Possible solution The program lasts too long. • Select the TimeSaver option to shorten the program time (if applicable). • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. The remaining time in the • This is not a defect. The appliance is working correctly. display increases and skips nearly to the end of program time. The options of the program have to be set again every time.
ENGLISH 21 Problem Possible cause and solution Poor drying results. • Tableware has been left for too long inside a closed appliance. • There is no rinse aid or the dosage of rinse aid is not enough. Set the rinse aid dispenser to a higher level. • Plastic items may need to be towel dried. • For the best drying performance activate the option XtraDry and set AirDry. • We recommend to always use rinse aid, even in combination with multi-tablets.
www.aeg.com Problem Possible cause and solution Limescale deposits on the tub and on the inside of the door. • Clean the appliance with appliance cleaners which are particularly suitable for this purpose. • Try different detergent. • Contact the detergent manufacturer. Dull, discoloured or chipped tableware. • Make sure that only dishwasher-safe items are washed in the appliance. • Load and unload the basket carefully. Refer to basket loading leaflet. • Place delicate items in the upper basket.
ENGLISH 23 14. INSTALLATION There should be a minimum 2mm gap between the top of the dishwasher and underside of bench top Remove entire plastic membrane from sink trap spigot & fit drain hose to spigot with clamp The hose should not be extended by more than 2 metres or water pumpout problems may occur SINK Secure dishwasher with brackets or screws provided DISHWASHER Gap on both sides should be equal, & no greater than 5 mm per side.
www.aeg.com Once the installation is completed, make sure that the bottom of the adjustable plinth is aligned with the floor. 14.3 Water inlet hose Connect the inlet hose to a water tap with an external BSP thread spout of 3/4''. For best washing performance it is recommended to connect the appliance to a cold water supply. Energy savings can be made by connecting the appliance to a Solar water system and using economy options, however the water temperature must not exceed 60° C.
ENGLISH 25 Remove entire internal membrane 15. WARRANTY FOR SALES IN AUSTRALIA AND NEW ZEALAND ALL AEG BRANDED APPLIANCES This document sets out the terms and conditions of the product warranties for AEG Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance. This warranty is in addition to other rights you may have under the Australian Consumer Law. 1.
www.aeg.com transportation, travel and delivery of the Appliance to and from Electrolux or its ASC. Travel and transportation will be arranged by Electrolux as part of any valid warranty claim. 6. Proof of purchase is required before you can make a claim under this warranty. 7. Exclusions: You may not make a claim under this warranty unless the defect claimed is due to faulty or defective parts or workmanship.
ENGLISH 27 Important Notice Before calling for service, please ensure that the steps listed in clause 8 above have been followed. SERVICE AUSTRALIA aegaustralia.com.au FOR SERVICE or to find the address of your nearest state service centre in Australia PLEASE CALL 1300 363 664 OR EMAIL customercare@aegaustralia.com.au FOR SPARE PARTS or to find the address of your nearest spare parts centre in Australia PLEASE CALL 13 13 50 OR EMAIL customercare@aegaustralia.com.
117881891-A-212018 www.aeg.
