Read this instruction booklet and keep in a safe place The dishwasher must only be installed and connected by a specialist fitter. Our special antes for installation are given on pages 20-22. ‘The instructions in this book will enable you to use all the features on the machine to your best advantage, and if you spend a fettle time in following the instructions, your dishwasher will reward you with superb result.
Guide to machine For illustrations see pages 3,4, § Control panel interior Rear without baskets Fig.1 Fig. 2 Fig.
Guide to machine o 450 Universal programmer 50°C o 50 Economy programmer 50°C 500 Quick wash 50°C Programmer sequence indicator (fig. 1/1l} Pr-wash “ ' m Wash S, JIVES, Ny o Fijian Intermediate rinsing 2 [ Final rinse \D.s_l Hot air drying Indicator Lamps {fig. 1/1V) S Refill salt .
Guide to machine Crockery baskets The baskets are protected with polystyrene during transportation. Remove all polystyrene parts before using the machine. General advice on dish washing ® Economical dish washing: Collect the dirty dishes and stack them in your dishwasher, Only select a full wash programmer when both baskets are full A rinse and hold programmer can be detected during the day to prevent food soil from drying on before a full load has bean collected.
Safety Information ® This is a domestic dishwasher for domestic use only. it must only be used for washing articles recommended by the manufacturer for dish washing by machine and then following the instructions contained in this bookie, The machine must be installed and cared for and maintained as instructed in this instruction booklet, any initialization instructions and any supplementary instructions supplied with the machine.
Setting the water hardness ~ adding dishwasher salt Your dishwasher is equipped with a water softens which transforms the “hard” water anti “soft” water required for washing. To regenerate the water softener the salt container in the bottom of the wash tub (fig. 2/B} must contain dishwasher salt at all times. At the end of each programmer the water softener is autocratically re-generated using some of the fast from the salt container.
Setting the water hardness — adding dishwasher sat The salt you require is special salt suitable for domestic dishwashers. On no account should table salt, cooking salt, road salt or processed sea salt be used, because they contain substances adversely affecting the water softener. Important! Detergents and salt are very often available in very similar rooking packaging.
Adjusting the rinse aid dosage The adjuster to alter the quantity of rinse afd tang dispensed is located in the filer neck {fig. 9). The quantity can be varied from 1-6¢¢ and the corresponding numbers are shown on the adjuster. To after the setting, move the arrow fo anther sifting using a screwdriver or Cain. The machine is set to dispense 3cc rinse aid {arrow Is set 1o *3") automatically during the final rinse.
Loading the machine Before you load the machine remove any remaining food and banes from the plates and soak saucepans with burnt on food as you would when washing up by hand. The easiest way to goad a basket is farm back to front., Lower basket (fig. 12): Large heavily soiled dishes are best cleaned in the dower basket. Pull out the lower basket as far as the stops and stack it with large #rems: plates, serving dishes, serving plates and saucepans as illustrated.
Programmer chart Programmed '| suitable for: Setting the programmer: Turn dastardliness on/oft actor switch and programmer 16 symbol: button: Rinse and Rinsing heavily A l doth soled items which .
Programmer chart rinsing, final tinge, drying Programmer Programmer Energy Water Sequence duration in minutes | consumption consumption on cold water (kWh) on cold in liters supply water supply Pr-rinse 11 0.1 8 Pr-wash, wash, intermediate vines, final rinse, drying Pr-wash, wash, 75 16 20 intermediate rinsing, fiat rinse, drying Pr-wash, wash, 62 10 20 intermediate ringing, fiat rinse, drying Wash, intermediate 52 09 15 rinsing, final rinse, drying Wash, intermediate 33 0.
Switching on {programmer chart see previous page) 1. Fully open the water tap. Important: f the dishwasher was started but the water tap had not been opened, switch off the machine, fully open the water tap, switch on the machine and start the programmer again, 2. Turn the start/indicator switch {fig. 131} clockwise to symbol Press the on button and the programmer button required (fig. 1), The machine “on” light is on and the red programmer indicator above the selected programmer is also on.
Cleaning the filters Coarse fitter {fig. 15) Remove the coarse filler and brush it clean under running water. Check the lower half of this fighter also and remove the food residues which may be trapped there. Note that the upper cylindrical section of the coarse fighter can be lifted out (fig, 16). When replacing ensure that the upper section sits straight and tight before re-inserting the coarse filter Fine filter {fig. 17) Clean the fine filter {a) and micro filter (b} as and when necessary.
¥ you think your machine is not working properly ® if the machine is connected {0 a hot file supply (max. 60°C) only economical if hot water is available “nearly free of charge” ~ do not use 50°C programmed to allow detergent sufficient ime to work. ® Did you top up the salt container? If the water hardiness in your area is over 10 degrees and your dishwasher is operate without sat, the result may te affected adversely and white and yellow chalk deposits will remain on your dishes.
Service Use our check fist on pages 17/18 t make sure you cannot rectify the fault yourself. # if you call out a service engineer in connection with one of the problems listed the cost invoiced will have to be passed on 10 yau even during the warranty period. The same applies to wrong usage or misuse of the machine. & Therefore, folio the instructions in this. bookie and any other of our recommendations closely.
Information for the installer Installation The appliance must stand level and on a firm floor. The floor should be clean and free from fiver polish and grease. The appliance has adjustable feet. If necessary adjust feet. Should a freestanding machine be built under & warlock in a built-in kitchen, the table top of the machine can be removed.
Information for the installer Water discharge At the rear of the making the drain hose is secured with plastic straps which must be removed. Route the drain hose along the recess provided at the rear of the dishwasher (fig. 3/b}. The outlet end of the hose is 19 mm diameter and should it any available sink rap connections and is secured by means of the hose clip supplied. Should you wish to hook the drain hose note a sink use the plastic hose holder supplied with the machine. See Illustration this page.
Information for the installer Anti-flood system — AQUA-LOCK The dishwasher is equipped with AQUA-LOCK anti-flood devices. The machine has an overflow protection which prevents excess water from entering the machine and a leakage protection underneath the machine {a float in the base of the machine). The float Is activated by leakage from the appliance. The AQUA-LOCK system also monitors the double-skin outset hose for defects.
Technical data Capacity according to 1EC pub, 436: 12 place settings including serving dishes. Water pressure min. 1 bar =10 N/em? = 0.1 Pampas, 15 psi max. 10 bar (=100 N/em? = 1 Pampas, 150 psi The dishwasher complies with the radio interference requirements of the EEC Directives 82/489/EEC and the standard EN 80555 part VOE 0838 part 1-3. June 1987, The consumption values gusted in the product information refer to the universal 85°C programmer.
AEG Tannhauser AG Pontiac 1056 D-8500 Nirenberg 1 © Copyright by AEG H 246 257 040 0191102 AEG Domestic Appliances Ltd Customer Care Department 58-77 High Street Slough Berkshire SL1 1DZ Telephone: 08705 350350
