Contents Page Description When using your new hob units for the first time Po wet consumption The automatic disc Suitable cooking utensils Connecting and fitting instructions for the electrician Assembly instructions Hob care
These operating instructions reef. built-in electric hob units. the range of AEG The number of your model is quoted on the rating plate of the appearance. Please note inch measurements are for guidance only — always use the millimeter or centimeter measurements, Description The hob unit range comprises the following models: EKE 1 one rectangular automatic plate with control EKE 2 two automatic plates of 145 and 180 mm {7") dia resp. with control switch.
Operation A control! knot with a setting range of 1—12 is provided for the plate with temperature regulator {models EKE 1 and EKE 2 only}. The numbers are subdivided into four groups of three numbers each, .Simmering” 4 i 8§ ,Strong heat, boiling™ 7 i @, Heavy boiling, genie frying” 10 112 L Strong frying® (deep-frying}. As a general guide, start with the underlined figure and adjust the setting up or down as necessary. You will soon find the correct settings for your own particular requirements.
Being a temperature-controlled p. | it can also be used for automatic cooking, i. @. you can select the required range (simmering, cooking or frying) right from the start, The food will then reach the set temperature fairly quickly as the temperature regulator maintains fut cutout unit the appropriate temperature is reached, The conventional method, still preferred by the majority of housewives, is also possible; i. &.
Dimensions for the installation ¥0 or mare built-in hob units or deposit pistes.
Connecting two built-in hob units it top covering strip == retaining strip underneath = screw off} = seal ~ mom | 5 = connecting strip front and back 8 = sheet metal screw off)
Assembly instructions Place the hobs SIDS by side with the plates facing down. Lousily screw on the connecting bars — see fig. 5 — using the sheet metal screws provided — see fig. 6. Insert the covering strip — see fig. 1 — with the seal — fig. 4 — between the hob units (from underneath). Position and loosely screw on the retaining bar — fig. 2 — using the screws provided — ses fig. 3. Push the hob units together and tighten the screws of connecting bar and retaining strip.
