User manual

INSTALLATION
22
CONNECTION IN DUCTING VERSION
When installing the ducting version, connect the
hood to the chimney using either a flexible or rigid
pipe ø 150 or 120 mm, the choice of which is left
to the installer.
To install a ø 150
• Toinstallthedumper10.
• Fixthepipeinpositionusingsufficientpipeclamps
(not supplied).
To install a ø 120
• Toinstallaø120mmairexhaustconnection,insert
the reducer flange 9 on the dumper 10.
• Fixthepipeinpositionusingsufficientpipeclamps
(not supplied).
• Removeanyactivatedcharcoalfilters.
CONNECTION IN RECYCLING VERSION
• InserttheConnectorextensions14.1intothesideof
the Connector 15.
• InserttheConnector15intotheSupportbracket7.3
and fix it with the screws.
• FastentheSupportbracket7.3,fixingittotheupper
part with the Screws.
• Make sure that the Connector extensions outlet
14.1 is in correspondence with the Chimney open-
ings both horizontally and vertically.
• Join the Connector15totheHoodcanopyoutlet
usingarigidorflexiblepipeø¸150mm,selectionof
which is at the discretion of the installation techni-
cian.
• MakesurethattheActivatedcharcoalodourfilter
has been fitted.












