DD9996-B Cooker Hood Operating and Installation Instructions
Thank you for buying an AEG product. To enable you to use your appliance effectively and safely, please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further information on AEG Products, please contact our Customer Services Department. For general enquiries concerning your AEG appliance or for further information, visit our website at http:\\www.aeg.co.
IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Services Department. Installation • Any installation work must be undertaken by a qualified electrician or competent person.
YOUR APPLIANCE ���� ���� ����� ����� 4
OPERATING INSTRUCTIONS � � Key � � � � � � � � Function Display A Upper panel closed: when pressed for about two sec-ond it opens the upper panel. It switches the motor on at the latest selected speed.Upper panel open: when shortly pressed it switches the motor and the lights on/off. It stops all function and closes the panel Indicates the selected speed. B Decreases the suction speed. Number of lit LEDS decreases. C Increases the suction speed. Number of lit LEDS increases.
OPERATING INSTRUCTIONS This cooker hood can be used to recirculate or extract contaminated air. ��� Recirculation Mode � The cooker hood is supplied specified for use in the recirculation mode with the charcoal filter fitted. The contaminated air is cleaned by passing through the filters and than back into the kitchen. ��� �� The activated charcoal filter absorbs odours arising from cooking. In use it will slowly become saturated in grease and less effective.
MAINTENANCE AND CLEANING Before carrying out any maintenance or leaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning The metal casing, grille and chimney should be cleaned at least once a month to keep it looking like new. Wipe over the hood with a soft cloth wrung out in mild soapy water and then dry thoroughly.
MAINTENANCE AND CLEANING Alarm signal reset • Stop the motor and switch off the lights. • Press the G-key for at least 2 seconds. Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. Charcoal Filters In the recirculation mode the charcoal filters absorb smells and unwanted odours. This filter cannot be washed or regenerated. It must be replaced when the C appears on the display or at least once every 4 months.
MAINTENANCE AND CLEANING Changing the Halogen Spot Lamp • Extract the lamp from the lamp holder by pulling gently. • Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. Replacement filters and light bulbs can be obtained from your local Service Force Centre. Replacing the fuser The hood panel opening and closing mechanism is controlled by a starter motor which is activated by a fuser. This fuser works only on the starter motor.
SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Solution Symptom • Check the hood is connected to the electricity supply. • Check that the fan speed control is set to 1, 2 or 3. The cooker hood will not start The cooker hood is not working effectively • The fan speed is set high enough for the task. • The grease filter is clean. • The kitchen is adequately vented to allow the entry of fresh air.
GUARANTEE CONDITIONS Standard Guarantee Conditions We, AEG, undertake that if within 12 months of the date of the purchase this AEG built-in appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option, repair or replace the same FREE OF ANY CHARGE for labour, materials and carriage on condition that: • The appliance has been correctly installed and used only on the electrical supply stated on the rating plate.
INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way.
INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. Unpacking Installation Requirements 2.1 1 Upper chimney 2.
INSTALLATION INSTRUCTIONS Wall drilling and bracket fixing As a first step, proceed with the following drawings: • a vertical line up to the ceiling or up to the upper limit, at the centre of the area in which the hood is to be fitted; • a horizontal line at a minimum 960 mm above the cooker top. • Mark a point (1) on the horizontal line, 292 mm to the right of the vertical reference line. • Repeat this operation on the other side, checking that the two marks are levelled.
INSTALLATION INSTRUCTIONS Hood body mounting • Firstly, it is necessary to adjust the two Vr-screws of the 11a-brackets, at minimun (B). • Hang the hood body on the two brackets 11a. • Connect the hood to the mains supply by means of a bipolar switch with at least 3 mm contact gap. • see Part USE to open the upper panel • Remove the metal filters by using the handles • In order to align the hood it is necessary to adjust the Vr-screws from inside the hood. • Fasten the safety screw 11.
INSTALLATION INSTRUCTIONS Electrical connection and working test: • Connect the hood to the mains supply. • Open the upper panel by pressing the A-key (See Part “USE” ) for at least 2 seconds. • Remove the metal filters (See Part “MAINTENANCE”) and make sure that the connector piece of the supply cable is correctly inside the hood socket.
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
