User manual

6
EN
INSTALLATION
Wall drilling and bracket xing
Wall marking:
• Drawaverticallineonthesupportingwalluptotheceiling,orashighaspractical,atthecentreof
theareainwhichthehoodwillbeinstalled.
• Drawahorizontallineat1040mmabovethehob.
• Placebracket7.2.1onthewallasshownabout1-2mmfromtheceilingorupperlimitaligningthe
centre(notch)withtheverticalreferenceline.
• Markthewallatthecentresoftheholesinthebracket.
• Placebracket7.2.1onthewallasshownatXmmbelowtherstbracket(X=heightoftheupper
chimneysectionsupplied),aligningthecentre(notch)withtheverticalline.
• Markthewallatthecentresoftheholesinthebracket.
• Markareferencepointasindicatedat116mmfromtheverticalreference.
• Repeatthisoperationontheotherside.
• Drillø8mmholesatallthecentrepointsmarked.
• Insertthewallplugs11 intheholes.
• Fixthelowerbracket7.2.1byusingthe12ascrews(4,2x44,4)supplied.
• Fixtheupperbracket7.2.1andtheairoutletconnectionsupport7.3togetherusingthe2screws
12a(4,2x44,4)supplied.
• Insertthetwoscrews12a(4,2x44,4)suppliedinthehoodbodyxingholes,leavingagapof5-6
mmbetweenthewallandtheheadofthescrew.








