Operation Manual
24
1. Before rst use. Remove all
adhesive remains and gently rub
with a dampened cloth. Position the
steam generator iron horizontally
on the ironing-board or on a heat
resistant, secure surface at the same
height as an ironing-board. Unwind
and straighten the power cord and
the steam cord. When turned on for
the rst time, temporary vapours/
odours may occur.
2. Open the water tank lid. Fill
the water tank using cold water.
It is recommended to use AEG
AquaSense ltered water, taking
out impurities like limescale.
Otherwise use destilled water. If
the tap water is particularly hard,
use a mix of 50% destilled water
and 50% tap water. Empty the
water tank to rinse out any foreign
particles which may remain from
the manufacturing process.
3. Always rell the water tank to
MAX level using cold water (A).
Replace the water tank lid.
Caution! Never operate the
appliance without any water in the
tank.
4.
Connect the steam generator iron
to the mains supply. Press the power
button (A). Turn the temperature
selector clockwise to maximum
setting (B). The temperature
indicator light on the iron will
illuminate. Then, select a steam level
by turning the
steam level control
knob
between low - medium - high
steam (C).
5.
When the temperature indicator
light turns on, the steam station is
pre-heating. When the light turns o,
it is ready to be used. Press and hold
the steam button for some seconds
to get steam. Then hold for a few
more seconds in order to clean the
steam generating system.
6.
Iron an old towel, to ensure that
any residues inside the iron are not
transferred to the laundry.
If necessary, wipe the soleplate with
a slightly damp cloth.
GB
Getting started
B
C
A
DBS7135_Safirina_SteamStation_BASE_AEG.indd 24 2015-05-25 10:18:23