User manual

76
What to do if ...
If you are unable to remedy the fault with the above assistance,
please contact your specialist dealer or AEG Service Force Centre.
Symptom Possible cause Remedy
The cooking zones do
not work.
The appropriate cooking
zone has not been switched
on.
Switch on the cooking zone.
The circuit breaker (at the
household fuse box) has
tripped or the fuse has
blown.
Check the circuit breaker or
fuse.
“-” appears in the
cooking zone display
The mains switch N has
been switched off and the
ring switches have not been
turned to zero.
Turn the ring switches to “0”
and then select the required
heat setting.
The oven does not heat
up.
The oven has not been
switched on.
Switch on the oven.
The time has not been set. Set the time.
The necessary settings have
not been made.
Check the settings.
The oven safety cut-out has
been triggered.
See
Safety Cut-out.
The circuit breaker (at the
household fuse box) has
tripped or the fuse has
blown.
Check the circuit breaker or
fuse.
If the circuit breaker trips or
the fuse blows several times,
please contact an approved
electrician.
The oven lighting does
not come on.
The oven light bulb is faulty.
Change the oven light bulb
(see Cleaning and Care).
Pyroluxe is not working
(“tEL” appears in the
time display)
The oven shelf runner has
not been removed
Remove the oven shelf run-
ner
The oven door is locked Appliance is not connected
to the mains; door lock has
been activated.
Connect the appliance and
wait at least 10 seconds until
the red indicator goes out.