User manual

Problem Possible cause Remedy
The descaling procedure is
interrupted before it finishes.
The function was stopped by
the user.
Repeat the procedure.
There is no water inside the
baking tray after the desca-
ling procedure.
You did not fill the water
drawer to the maximum lev-
el.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The baking tray is on a
wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the baking tray on
the first shelf position.
The cleaning function is in-
terrupted before it finishes.
There was a power cut. Repeat the procedure.
The cleaning function is in-
terrupted before it finishes.
The function was stopped by
the user.
Repeat the procedure.
There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.
You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.
Cover all parts of the cavity
with a thin layer of the deter-
gent. Spray the detergent
evenly.
There is no good perform-
ance of the cleaning proce-
dure.
The initial oven cavity tem-
perature of the steam clean-
ing function was too high.
Repeat the cycle. Run the cy-
cle when the appliance is
cold.
There is no good perform-
ance of the cleaning proce-
dure.
You did not remove the side
grids before the start of the
cleaning procedure. They
can transfer heat to the walls
and decrease the perform-
ance.
Remove the side grids from
the appliance and repeat the
function.
There is no good perform-
ance of the cleaning proce-
dure.
You did not remove the ac-
cessories from the appliance
before the start of the clean-
ing procedure. They can
compromise the steam cycle
and decrease the perform-
ance.
Remove the accessories
from the appliance and re-
peat the function.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
ENGLISH 61