Operating instructions

63
CONNECTOR LED COLOUR STATUS INTERPRETATION
X40 1
yellow
OFF A connection to the preceding device (in the
direction of the master) is in place
X40 1
FLASHING
Not all data could be sent to the preceding (in
the direction of the master) device (dynamic
communication error)
X40 1 If LED 3 is also flashing then a ring has been
made with the RJ45 cables
X40 1
ON
There is no RJ45 cable connected
X40 1 Connector incorrectly connected
X40 1 (the RJ45 cable is not inserted into X41 of the
preceding Thyro-P)
X40 2
green
OFF An incorrect cable was used (e.g. cross-over
cable instead of the necessary patch cable)
X40 2 FLASHING Thyro-P is switched off
X40 2 ON Thyro-P is master
Thyro-P is connected to the preceding device (in
the direction of the master)
CONNECTOR LED COLOUR STATUS INTERPRETATION
X41 3
yellow
OFF Connection to the next slave is in place
X41 3
FLASHING
More than 32 units are connected in the dASM
group
X41 3 If LED 1 is also flashing then a ring has been
made with the RJ45 cables (then: no device is
master, no dASM functionality)
X41 3
ON
There is no RJ45 cable connected
X41 3 Connector incorrectly connected (the RJ45
cable is not inserted into X40 of the preceding
Thyro-P)
X41 3 An incorrect cable was used (e.g. cross-over
cable instead of the necessary patch cable)
X41 4
green
OFF No additional units are connected
X41 4 FLASHING The additional units form their own group
X41 4 ON Additional units are in the same group
The LEDS can be interpreted as follows: