Operating instructions

39
X = Default settings
Data logger
K1 K2 K3
LED Control Lock
LED Limit
LED Pulse Lock
LED Fault
LED Overheat
Pulse inhibit
Reset trigger
Bus
Thyro-Tool Family
LBA-2
Comments
RS232 interface active - - X
Optical fiber interface active - - X
Negative power - X X
Test external converter on correct con-
nection
Communication error - X X
RS232 or fibre optic interfaces,
dyn. Messages
No extension - - X
No bus card available
(message after approx. 10sec)
External error message - X X External message to forward, e.g. to relay
After reset - - X
Mains failure detection of control device
supply
Controller inhibit X X X X Controller inhibit is active
Invalid data in EEProm - X X
All parameters are useless
(factory and customer parameter)
Limit X X X X X dyn., non regulated values are at limit
Unit excess temp. X X X X X X
Fast current shut-off - X X Peak value message U, I
Incorrect no. of dASM
devices
- X X
Undercurrent in load circuit X X X
Load monitoring:
Undercurrent message
Overcurrent in load circuit X X X
Load monitoring:
Overcurrent message
i2t current limit is exceeded - X X
Mains OK X - - X Mains failure detection for MOPO feature
Undervoltage at mains input X X X Mains voltage monitoring L1 / L2 / L3
Overvoltage at mains input X X X Mains voltage monitoring L1 / L2 / L3
SYNC error X X X X X
Synchronization error e.g. by soft mains or
wiring error
dASM power threshold is
exceeded
- X X
MOSI: Peak current limit X X X
Temperature sensor
Sensor breakage /
short circuit
X X X X X X
TAB. 5 ERROR AND DATA LOGGER MESSAGES