Operating instructions

3.5.1 LBA-2

DISPLAY OF ERROR MESSAGES

If there are status messages, a red or yellow reference will appear in the LBA-2 status line (see

illustration).

Yellow: Status messages / Warnings

Red: Error messages

Incl. further status messages

By pressing the status ﬁeld, individual events can be displayed on the LBA-2 in the data logger

view. Then previous events can also be seen. Occurring messages, which are recorded by the data

logger, are also secured just like the process data of line chart and are therefore documented. The

number of saved messages is nearly unlimited which can be used for analyzing purposes.

The data logger can also be set up as start screen.

NOTE

If the SD card is removed for analyzing purposes, it is required to shut down the LBA-2 by using the

OFF button.

ACKNOWLEDGE ERROR MESSAGES

Error messages and warning can be reset in the LBA-2 menu (page 2/2: ACKNOWLEDGE ERRORS).

ACTIVATE MESSAGES FOR DATA LOGGER

To activate messages in Thyro-P data logger, they have to be parameterized. This has to done by

the LBA-2 menu:

After selecting menu SETTINGS / THYRO-P (page 3/3) / DATA LOGGER, the messages are shown

in order and can be selected.

3.5.2 THYRO-TOOL FAMILY

Using the Thyro-Tool Family and active line chart, errors and messages that occur will be displayed

in a window and stored on the hard drive as per the line chart. Via a bus interface option (e.g.,

Proﬁbus DPV1, Proﬁnet, Modbus TCP, EthernetIP, Modbus RTU, DeviceNet), a message will be

communicated automatically. As already mentioned, the status messages generated from the

Thyro-P (errors, warnings, messages) refer either to the load or the power controller in the Thyro-

Tool Family. Depending on the application, either warnings or status messages will be displayed.

As a deviation from the default factory setting, all messages can be switched on the data logger, on

the relays and on the LEDs. The default factory settings are as follows:

Thyro-P